Search results
Results from the WOW.Com Content Network
At 10 000 ppm the solution is a deep red colour. As the concentration decreases the colour becomes orange, then a vibrant yellow, with the final 1 ppm sample a very pale yellow. In science and engineering , the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities , e.g. mole fraction or ...
Water chemists measure water impurities in parts per million (ppm). For understandability, hardness ordinarily is expressed in grains of hardness per gallon of water (gpg). The two systems can be converted mathematically.
Here are the conversion factors for those various expressions of wind speed: 1 m/s = 2.237 statute mile/h = 1.944 knots 1 knot = 1.151 statute mile/h = 0.514 m/s 1 statute mile/h = 0.869 knots = 0.447 m/s. Note: 1 statute mile = 5,280 feet = 1,609 meters
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
The conversion equations depend on the temperature at which the conversion is wanted (usually about 20 to 25 °C). At an ambient sea level atmospheric pressure of 1 atm (101.325 kPa or 1.01325 bar), the general equation is:
Since one degree KH = 17.848 mg/L CaCO 3, this solution has a KH of 4.0052 degrees. Carbonate hardness should not be confused with a similar measure Carbonate Alkalinity which is expressed in either [milli[equivalent]s] per litre (meq/L) or ppm. Carbonate hardness expressed in ppm does not necessarily equal carbonate alkalinity expressed in ppm.
ppm = ppm • 1e-6 billiard = billiard • 1e15 ... mg/L = mg/L • CONVERT mg.l-1 = mg/l mg/l = mg/l • CONVERT. Fracture toughness. MPa.m.5 = MPa⋅m 1/2 kPa.m.5 ...
A parametric value in this context is most commonly the concentration of a substance, e.g. 30 mg/L of iron. It may also be a count such as 500 E. coli per litre or a statistical value such as the average concentration of copper is 2 mg/L.