enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. IPC (electronics) - Wikipedia

   en.wikipedia.org/wiki/IPC_(electronics)

   IPC standards are used by the electronics manufacturing industry. IPC-A-610, [4] Acceptability of Electronic Assemblies, is used worldwide by original equipment manufacturers and EMS companies. There are more than 3600 trainers worldwide who are certified to train and test on the standard. Standards are created by committees of industry volunteers.

3. Wiring Harness Manufacturer's Association - Wikipedia

   en.wikipedia.org/wiki/Wiring_Harness_Manufacturer...

   The Wiring Harness Manufacturer's Association is a trade group for American manufacturers of wiring harnesses, electronic cable assemblies, and cord sets, along with their suppliers and distributors. [1] It publishes the widely used standard IPC/WHMA-A-620 Acceptability of Electronic Wire Harnesses and Cables jointly with IPC. [2]

4. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:

5. Cable harness - Wikipedia

   en.wikipedia.org/wiki/Cable_harness

   A cable laced wiring harness installed in a component of a Tesla coil Harness of car audio cables. A cable harness, also known as a wire harness, wiring harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. [1]

6. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

7. Hermes protocol - Wikipedia

   en.wikipedia.org/wiki/Hermes_protocol

   Hermes is a machine-to-machine communication standard used in the SMT assembly industry. [1]IPC-HERMES-9852. It is a successor to the SMEMA standard, introducing improvements such as: simpler physical wiring (Ethernet), use of popular data transmission formats (TCP/IP and XML), reduced number of barcode scanners (required only once at the beginning of the line), transmission of board data ...