Search results
Results from the WOW.Com Content Network
For consumer equipment it is −10 dBV, which is used to reduce manufacturing costs. [3] Expressed in absolute terms, a signal at −10 dBV is equivalent to a sine wave signal with a peak amplitude (V PK) of approximately 0.447 volts, or any general signal at 0.316 volts root mean square (V RMS).
The decibel watt (dBW or dB W) is a unit for the measurement of the strength of a signal expressed in decibels relative to one watt.It is used because of its capability to express both very large and very small values of power in a short range of number; e.g., 1 milliwatt = −30 dBW, 1 watt = 0 dBW, 10 watts = 10 dBW, 100 watts = 20 dBW, and 1,000,000 W = 60 dBW.
Audio engineers use dynamic range to describe the ratio of the amplitude of the loudest possible undistorted signal to the noise floor, say of a microphone or loudspeaker. [18] Dynamic range is therefore the signal-to-noise ratio (SNR) for the case where the signal is the loudest possible for the system. For example, if the ceiling of a device ...
In semi-professional and domestic equipment, the nominal level is usually −10 dBV. [3] This difference is due to the cost required to create larger power supplies and output higher levels. [4] In broadcasting equipment, this is termed the Maximum Permitted Level, which is defined by European Broadcasting Union standards.
In telecommunications, [1] particularly in radio frequency engineering, signal strength refers to the transmitter power output as received by a reference antenna at a distance from the transmitting antenna. High-powered transmissions, such as those used in broadcasting, are expressed in dB-millivolts per metre (dBmV/m).
dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels.For example, phase noise is expressed in dBc/Hz at a given frequency offset from the carrier. dBc can also be used as a measurement of Spurious-Free Dynamic Range between the desired signal and unwanted spurious outputs resulting from the use of signal converters such as a digital ...
A frequency ratio expressed in octaves is the base-2 logarithm (binary logarithm) of the ratio: = An amplifier or filter may be stated to have a frequency response of ±6 dB per octave over a particular frequency range, which signifies that the power gain changes by ±6 decibels (a factor of 4 in power), when the frequency changes by a factor of 2.
The Signal-to-quantization-noise ratio is a multiple of the bit depth. Audio CDs use a bit depth of 16-bits, while DVD-Video and Blu-ray discs can use 24-bit audio. The maximum dynamic range of a 16-bit system is about 96 dB, [10] while for 24 bit it is about 144 dB.