enow.com Web Search

  1. Ads

    related to: mortar mix for repointing bricks in america

Search results

  1. Results from the WOW.Com Content Network
  2. Repointing - Wikipedia

    en.wikipedia.org/wiki/Repointing

    German masons repointing a wall in 1948. Repointing is the process of renewing the pointing, which is the external part of mortar joints, in masonry construction. Over time, weathering and decay cause voids in the joints between masonry units, usually in bricks, allowing the undesirable entrance of water.

  3. Mortar (masonry) - Wikipedia

    en.wikipedia.org/wiki/Mortar_(masonry)

    Mortar holding weathered bricks. Mortar is a workable paste which hardens to bind building blocks such as stones, bricks, and concrete masonry units, to fill and seal the irregular gaps between them, spread the weight of them evenly, and sometimes to add decorative colours or patterns to masonry walls.

  4. Lime mortar - Wikipedia

    en.wikipedia.org/wiki/Lime_mortar

    This can help to prevent the older brick from spalling. Even when the brick is a modern, harder element, repointing with a higher ratio lime mortar may help to reduce rising damp. It may not be advisable for all consumers to use a straight lime mortar. With no Portland in the mix, there is less control over the setting of the mortar.

  5. Mortar joint - Wikipedia

    en.wikipedia.org/wiki/Mortar_joint

    This joint is best used when the wall is intended to be plastered or joints are to be hidden under paint. Because the mortar is not compressed, it is less water-resistant than some of the other designs. Tuckpointing This joint has mortar colored to match the bricks surrounding a line of white mortar to make the joints look very small.

  6. Tuckpointing - Wikipedia

    en.wikipedia.org/wiki/Tuckpointing

    Tuckpointing was a way of achieving a similar effect using cheap, unrubbed bricks; these were laid in a mortar of a matching colour (initially red, but later, blue-black bricks and mortar were occasionally used) and a fine fillet of white material, usually pipe clay or putty, pushed into the joints before the mortar set. [4]

  7. Parge coat - Wikipedia

    en.wikipedia.org/wiki/Parge_coat

    A parge coat is a thin coat of a cementitious or polymeric mortar applied to concrete or masonry for refinement of the surface. Pargeting is a more involved process, involving designs in relief created in the surface. Parging is usually applied with a trowel and pressed into the existing surface.

  1. Ads

    related to: mortar mix for repointing bricks in america