Search results
Results from the WOW.Com Content Network
The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or imperial definitions).
The IEEE symbol for the cubic foot per second is ft 3 /s. [1] The following other abbreviations are also sometimes used: ft 3 /sec; cu ft/s; cfs or CFS; cusec; second-feet; The flow or discharge of rivers, i.e., the volume of water passing a location per unit of time, is commonly expressed in units of cubic feet per second or cubic metres per second.
All this because of the lack in ability to do this simple calculation. I will illustrate here: 1 acre (1 foot thick) x # of gallons in a cubic foot. This is, simply 43560 (Cubic feet) x 7.48 gallons / cubic foot = 325,828.8 gallons - rounded to 325,829 gallons per acre foot (do it on a calculator!).
Most wet scrubbers used for particulate control operate with liquid-to-gas ratios in the range of 4 to 20 gallons per 1,000 actual cubic foot (0.5 to 3 litres per actual cubic metre). Depending on scrubber design, a minimum volume of liquid is required to "wet" the scrubber internals and create sufficient collection targets.
As the name suggests, an acre-foot is defined as the volume of one acre of surface area to a depth of one foot.. Since an acre is defined as a chain by a furlong (i.e. 66 ft × 660 ft or 20.12 m × 201.17 m), an acre-foot is 43,560 cubic feet (1,233.5 m 3).
Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. [1] This is the actual gas delivery with reference to inlet conditions, whereas cubic foot per minute (CFM) is an unqualified term and should only be used in general and never accepted as a specific definition without explanation.
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...
This volume of natural gas has the same energy content as one US gallon of gasoline (based on lower heating values: 900 BTU/cu ft (9.3 kWh/m 3) of natural gas and 114,000 BTU/US gal (8.8 kWh/L) for gasoline). [22] One GGE of CNG pressurized at 2,400 psi (17 MPa) is 0.77 cubic feet (22 litres; 5.8 US gallons).