Search results
Results from the WOW.Com Content Network
A local collision is a collision that occurs at the NIC, as opposed to on the wire. A NIC cannot detect local collisions without attempting to send information. On UTP cable, a local collision is detected on the local segment only when a station detects a signal on the RX pair at the same time it is sending on the TX pair. Since the two signals ...
An air gapped network (right) with no connection to a nearby internet-connected network (left) An air gap, air wall, air gapping [1] or disconnected network is a network security measure employed on one or more computers to ensure that a secure computer network is physically isolated from unsecured networks, such as the public Internet or an unsecured local area network. [2]
A local area network (LAN) is a computer network that interconnects computers within a single physical location. It is the most common type of computer network, used in homes and buildings including offices or schools, [ 1 ] [ 2 ] [ 3 ] for sharing data and devices between each other, including Internet access .
An active internet connection is required to be able to access all the best that America Online® offers. If you're using dial-up internet and can't connect, try the following troubleshooting steps: Check the dial tone - If you DO have one, it's likely the problem has something to do with your computer. If you DON'T, it's likely the problem has ...
A telecommunications network is a group of nodes interconnected by telecommunications links that are used to exchange messages between the nodes. The links may use a variety of technologies based on the methodologies of circuit switching, message switching, or packet switching, to pass messages and signals.
To tap a copper link as shown in the picture above it is not possible to just tap the middle of the wire because all you will see is a complex modulation of two signals. The only way to terminate the signal (as shown in the picture) is to use a PHY chip to separate the signal and then send the signal on to the link partner.
Home networks may use either wired or wireless connectivity methods that are found and standardized on local area networks or personal area networks. One of the most common ways of creating a home network is by using wireless radio signal technology; the 802.11 network as certified by the IEEE.
Internet connections can also be secured through the addition of a wireless router to an existing wired connection – a convenient method for Internet access provision in small centralized areas. Although wireless routers are generally reliable, their occasional failure means no Internet availability in that centralized area.