Search results
Results from the WOW.Com Content Network
The Advanced Host Controller Interface (AHCI) is a technical standard defined by Intel that specifies the register-level interface of Serial ATA (SATA) host controllers in a non-implementation-specific manner in its motherboard chipsets.
The appropriate driver must be loaded into the operating system to enable NCQ on the host bus adapter. [3] Many newer chipsets support the Advanced Host Controller Interface (AHCI), which allows operating systems to universally control them and enable NCQ. DragonFly BSD has supported AHCI with NCQ since 2.3 in 2009.
Intel Rapid Storage Technology (RST) is a driver SATA AHCI and a firmware-based RAID solution built into a wide range of Intel chipsets. Currently also is installed as a driver for Intel Optane temporary storage units. It contains two operation modes that follow two Intel specific modes rather than the SATA standard. The name modes and the ...
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
Although the AHCI block device driver gained the ability to display whether a device supports the TRIM operation in 10.6.6 (10J3210), [36] the functionality itself remained inaccessible until 10.6.8, when the TRIM operation was exposed via the IOStorageFamily and filesystem (HFS+) support was added.
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
Boomers grew up in a time when certain luxuries were just a normal part of life. Things that now seem completely out of reach for Millenials and Gen Z. From dirt-cheap real estate to airline ...
If you want AHCI then prepare the floppy disk that came with the motherboard (or make it with the motherboard CD) OR slipstream it onto Windows installation disk. Then install Windows normally. The only real danger here is if you install Windows in AHCI mode and later change it to IDE and vice versa. That causes BSODs and problems.