Search results
Results from the WOW.Com Content Network
Another type of SCR inverter circuit is the current source input (CSI) inverter. A CSI inverter is the dual of a six-step voltage source inverter. With a current-source inverter, the DC power supply is configured as a current source rather than a voltage source. The inverter SCRs are switched in a six-step sequence to direct the current to a ...
An and-inverter graph (AIG) is a directed, acyclic graph that represents a structural implementation of the logical functionality of a circuit or network. An AIG consists of two-input nodes representing logical conjunction , terminal nodes labeled with variable names, and edges optionally containing markers indicating logical negation .
A Z-source inverter is a type of power inverter, a circuit that converts direct current to alternating current. The circuit functions as a buck-boost inverter without making use of DC-DC converter bridge due to its topology. Impedance (Z) source networks efficiently convert power between source and load from DC to DC, DC to AC, and from AC to ...
A soft-switching three-level inverter (S3L inverter) is a high-efficiency power electronic inverter intended, in particular, for use with three-phase drives, as a grid-tie inverter for photovoltaic installations or wind turbines and in power supplies. [1] The topology was developed in 2009 at HTWG Konstanz (Constance University of Applied ...
This schematic diagram shows the arrangement of NOT gates within a standard 4049 CMOS hex inverting buffer. The inverter is a basic building block in digital electronics. Multiplexers, decoders, state machines, and other sophisticated digital devices may use inverters. The hex inverter is an integrated circuit that contains six inverters.
Push-pull converter (+12V → ±18V; 50W) as potted module. ① transformer; ② and ③ electrolytic capacitors vertical and horizontal mounted; ④ discrete circuit board in through-hole technology A push–pull converter is a type of DC-to-DC converter , a switching converter that uses a transformer to change the voltage of a DC power supply.
Schematic capture or schematic entry is a step in the design cycle of electronic design automation (EDA) at which the electronic diagram, or electronic schematic of the designed electronic circuit, is created by a designer. This is done interactively with the help of a schematic capture tool also known as schematic editor. [1]
Figure 2. Power part of a synchronverter Figure 3. The per-phase model of an SG connected to an infinite bus. Synchronverter structure can be divided into two parts: power part (see figure 2) and electronic part. The power part is energy transform and transfer path, including the bridge, filter circuit, power line, etc.