Search results
Results from the WOW.Com Content Network
Beam bridges are the simplest structural forms for bridge spans supported by an abutment or pier at each end. [1] No moments are transferred throughout the support, hence their structural type is known as simply supported. The simplest beam bridge could be a log (see log bridge), a wood plank, or a stone slab (see clapper bridge) laid
Double tee structure is an alternative for short to medium spans between 40 and 90 feet (12 and 27 m). There are many standards such as double-tee beam of Texas Department of Transportation and the Northeast Extreme Tee (NEXT) Beam of the Northeast. [8] A benefit of using double tees for bridge replacements is to shorten the construction time.
Beam – A measure of the width of the ship. There are two types: Beam, Overall (BOA), commonly referred to simply as Beam – The overall width of the ship measured at the widest point of the nominal waterline. Beam on Centerline (BOC) – Used for multihull vessels. The BOC for vessels is measured as follows: For a catamaran: the ...
Deflection (f) in engineering. In structural engineering, deflection is the degree to which a part of a long structural element (such as beam) is deformed laterally (in the direction transverse to its longitudinal axis) under a load.
In engineering, span is the distance between two adjacent structural supports (e.g., two piers) of a structural member (e.g., a beam). Span is measured in the horizontal direction either between the faces of the supports (clear span) or between the centers of the bearing surfaces (effective span): [1] A span can be closed by a solid beam or by ...
The beam of a ship is its width at its widest point. The maximum beam (B MAX ) is the distance between planes passing through the outer sides of the ship, beam of the hull (B H ) only includes permanently fixed parts of the hull , and beam at waterline (B WL ) is the maximum width where the hull intersects the surface of the water.
A girder bridge is a bridge that uses girders as the means of supporting its deck. [1] The two most common types of modern steel girder bridges are plate and box. [citation needed] The term "girder" is often used interchangeably with "beam" in reference to bridge design.
Five definitions of the beam width are in common use: D4σ, 10/90 or 20/80 knife-edge, 1/e 2, FWHM, and D86. The beam width can be measured in units of length at a particular plane perpendicular to the beam axis, but it can also refer to the angular width, which is the angle subtended by the beam at the source.