enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fixture (tool) - Wikipedia

   en.wikipedia.org/wiki/Fixture_(tool)

   A robust robotic arc welding fixture is a part-holding tool used to constrain components for welding in an automated system. [15] Welding fixtures locate parts using these clamps to secure important aspects of the subcomponent, such as holes, slots, or datum surfaces. Careful considerations must be made when designing welding fixtures.

3. Holdfast (tool) - Wikipedia

   en.wikipedia.org/wiki/Holdfast_(tool)

   A holdfast or hold fast is a form of temporary clamp used to hold a workpiece firmly to the top or side of a wooden workbench or the top of an anvil. [1] A form of bench dog, a traditional holdfast has either a curved or flat top. Its shank is slid loosely into a “dog” hole in the bench or anvil until the tip of its hook touches the work.

4. Locking pliers - Wikipedia

   en.wikipedia.org/wiki/Locking_pliers

   A typical use would be to hold metal parts in place for welding. Other uses include holding a nut or bolt that has been 'rounded', helping pull out nails, holding pipes without squeezing them, and acting as temporary substitute levers or knobs on equipment and machinery.

5. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A chuck is a specialized type of clamp used to hold an object with radial symmetry, especially a cylinder. In a drill, a mill and a transmission, a chuck holds the rotating tool; in a lathe, it holds the rotating workpiece. [1] Chucks commonly use jaws to hold the tool or workpiece.

6. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 22 ] : 149 [ 19 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...