enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. dGH - Wikipedia

    en.wikipedia.org/wiki/DGH

    In water testing hardness is often measured in parts per million (ppm), where one part per million is defined as one milligram of calcium carbonate (CaCO 3) per litre of water. Consequently, 1 dGH corresponds to 10 ppm CaO but 17.848 ppm CaCO 3 which has a molar mass of 100.09 g/mol.

  3. Carbonate hardness - Wikipedia

    en.wikipedia.org/wiki/Carbonate_hardness

    In a solution where only CO 2 affects the pH, carbonate hardness can be used to calculate the concentration of dissolved CO 2 in the solution with the formula CO 2 = 3 × KH × 10 (7-pH), where KH is degrees of carbonate hardness and CO 2 is given in ppm by weight.

  4. dKH - Wikipedia

    en.wikipedia.org/wiki/DKH

    As a unit 1 dKH is the same as 1 °dH which is equal to approximately 0.1786 mmol/L or 17.86 milligrams (mg) of calcium carbonate per litre of water, i.e. 17.86 ppm. [ citation needed ]

  5. Grain per gallon - Wikipedia

    en.wikipedia.org/wiki/Grain_per_gallon

    Water chemists measure water impurities in parts per million (ppm). For understandability, hardness ordinarily is expressed in grains of hardness per gallon of water (gpg). The two systems can be converted mathematically.

  6. Parts-per notation - Wikipedia

    en.wikipedia.org/wiki/Parts-per_notation

    Fluorescein aqueous solutions, diluted from 10,000 to 1 parts-per-million in intervals of 10 fold dilution. At 1 ppm the solution is a very pale yellow. At 1 ppm the solution is a very pale yellow. As the concentration increases the colour becomes a more vibrant yellow, then orange, with the final 10,000 ppm a deep red colour.

  7. Total dissolved solids - Wikipedia

    en.wikipedia.org/wiki/Total_dissolved_solids

    Bottled mineral water usually contains higher TDS levels than tap water.. Total dissolved solids (TDS) is a measure of the dissolved combined content of all inorganic and organic substances present in a liquid in molecular, ionized, or micro-granular (colloidal sol) suspended form.

  8. PPM - Wikipedia

    en.wikipedia.org/wiki/PPM

    Toggle the table of contents. PPM. ... Temperature coefficient, in parts per million per Kelvin (ppm/K) or per degree Celsius (ppm/C) This page was last edited on 13 ...

  9. Abundances of the elements (data page) - Wikipedia

    en.wikipedia.org/wiki/Abundances_of_the_elements...

    A. Earnshaw, N. Greenwood, Chemistry of the Elements, 2nd edition, Butterworth-Heinemann, (1997). ISBN 0-7506-3365-4 Appendix 4, Abundance of Elements in Crustal Rocks. From this source with some modifications and additions of later data: W.S. Fyfe, Geochemistry, Oxford University Press, (1974). Further referring to: