enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   Hex keys are best known as "Allen keys" or "Allen wrenches" in English-speaking countries like the UK, Australia, Canada and the U.S. and in Spanish-speaking countries such as Spain and Mexico (The "Allen" name is a registered trademark, originated by the Allen Manufacturing Company of Hartford, Connecticut, circa 1910. [1]

3. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

4. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

5. Allen (brand) - Wikipedia

   en.wikipedia.org/wiki/Allen_(brand)

   The terms "Allen wrench" (American English, though "Allen key" is also common in the US) and "Allen key" (British English) [3] are derived from the Allen brand name and refer to the generic product category "hex keys". W.G. Allen [4] filed the first related patent in 1909 for its recessed hex-driven safety screws, [5] a safety improvement over ...

6. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   Hexagonal (generally abbreviated to "hex") head widths (width across flats, spanner size) are for DIN 934 hex nuts and hex head bolts. Other (usually smaller) sizes may occur to reduce weight or cost, including the small series flange bolts defined in ISO 4162 which typically have hexagonal head sizes corresponding to the smaller 1st choice ...

7. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   Isometric projection of a grub screw with a hex socket head.. Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts.