Search results
Results from the WOW.Com Content Network
The pulse width must be long enough to ensure that the radar emits sufficient energy so that the reflected pulse is detectable by its receiver. The amount of energy that can be delivered to a distant target is the product of two things; the peak output power of the transmitter, and the duration of the transmission.
Aircraft and some missiles exploit this weakness using a technique called flying below the radar to avoid detection (nap-of-the-earth). This flying technique is ineffective against pulse-Doppler radar. Pulse-Doppler provides an advantage when attempting to detect missiles and low observability aircraft flying near terrain, sea surface, and weather.
Pulse-Doppler begins with coherent pulses transmitted through an antenna or transducer. There is no modulation on the transmit pulse. Each pulse is a perfectly clean slice of a perfect coherent tone. The coherent tone is produced by the local oscillator. There can be dozens of transmit pulses between the antenna and the reflector.
Pulse-based UWB systems, being the more common method associated with the term "UWB radar", are described here. A pulse-based radar system transmits very short pulses of electromagnetic energy, typically only a few waves or less. A very short pulse is, of course, a very rapidly changing signal, and thus occupies a very wide bandwidth.
The pulse-repetition frequency (PRF) is the number of pulses of a repeating signal in a specific time unit. The term is used within a number of technical disciplines, notably radar . In radar, a radio signal of a particular carrier frequency is turned on and off; the term "frequency" refers to the carrier, while the PRF refers to the number of ...
Sampling begins immediately after the radar transmit pulse ends. The sampling continues until the next transmit pulse begins. Sampling is repeated in the same location for the next transmit pulse, and the sample taken (at the same distance) with the first pulse is rotated 180 degrees and added to the second sample.
The radar mile is the time it takes for a radar pulse to travel one nautical mile, reflect off a target, and return to the radar antenna. Since a nautical mile is defined as 1,852 m, then dividing this distance by the speed of light (299,792,458 m/s), and then multiplying the result by 2 yields a result of 12.36 μs in duration.
Weather radar in Norman, Oklahoma with rainshaft Weather (WF44) radar dish University of Oklahoma OU-PRIME C-band, polarimetric, weather radar during construction. Weather radar, also called weather surveillance radar (WSR) and Doppler weather radar, is a type of radar used to locate precipitation, calculate its motion, and estimate its type (rain, snow, hail etc.).