enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Electrical conduit - Wikipedia

   en.wikipedia.org/wiki/Electrical_conduit

   Galvanized rigid conduit (GRC) is galvanized steel tubing, with a tubing wall that is thick enough to allow it to be threaded. Its common applications are in commercial and industrial construction. [1] It is designed to protect wire and connectors. Intermediate metal conduit (IMC) is a steel tubing heavier than EMT but lighter than RMC. It may ...

3. Galvanization - Wikipedia

   en.wikipedia.org/wiki/Galvanization

   Galvanized surface with visible spangle. Galvanization (also spelled galvanisation) [1] is the process of applying a protective zinc coating to steel or iron, to prevent rusting. The most common method is hot-dip galvanizing, in which the parts are coated by submerging them in a bath of hot, molten zinc. [citation needed]

4. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   When necessary, a double walled duct is used. This will usually have an inner perforated liner, then a 1–2" (2.5-5 cm) layer of fiberglass insulation contained inside an outer solid pipe. Rectangular ductwork commonly is fabricated to suit by specialized metal shops. For ease of handling, it most often comes in 4' (120 cm) sections (or joints).

5. Hot-dip galvanization - Wikipedia

   en.wikipedia.org/wiki/Hot-dip_galvanization

   Galvanised hand rail Crystalline surface of a hot-dip galvanized handrail, known as "spangle" Protective effect: completely rusted letter box mounted to a hot-dip galvanized wall Steel strip coming out of the zinc pot of a continuous vertical hot-dip galvanizing line. Hot-dip galvanization is a form of galvanization.

6. Springfield CU needs to know what your water lines are made ...

   www.aol.com/news/springfield-cu-needs-know-water...

   A magnet can be used to identify whether a pipe is galvanized steel or not. If it sticks, it means it is galvanized steel, so a photo can be taken with the magnet attached to be submitted to CU ...

7. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.