Search results
Results from the WOW.Com Content Network
Burning all the oxygen delivered by the compressor stages would create temperatures (3,700 °F (2,040 °C)) high enough to significantly weaken the internal structure of the engine, but by mixing the combustion products with unburned air from the compressor at (600 °F (316 °C)) a substantial amount of oxygen (fuel/air ratio 0.014 compared to ...
The three-zone (reduced from four from the prototype) afterburner, or augmentor, contributes to the stealth of the aircraft by having fuel injectors integrated into thick curved vanes coated with ceramic radar-absorbent materials (RAM). These vanes replace the traditional fuel spray bars and flame holders and block line-of-sight of the turbines.
It features an eight-stage axial-flow compressor powered by two turbine stages, and is capable of generating up to 2,100 lb f (9.3 kN) of dry thrust, or more with an afterburner. At full throttle at sea level, this engine, without afterburner, consumes approximately 400 US gallons (1,500 L) of fuel per hour.
The Pratt & Whitney F135 is an afterburning turbofan developed for the Lockheed Martin F-35 Lightning II, a single-engine strike fighter.It has two variants; a Conventional Take-Off and Landing variant used in the F-35A and F-35C, and a two-cycle Short Take-Off Vertical Landing variant used in the F-35B that includes a forward lift fan. [1]
The Pratt & Whitney J58 (company designation JT11D-20) is an American jet engine that powered the Lockheed A-12, and subsequently the YF-12 and the SR-71 aircraft. It was an afterburning turbojet engine with a unique compressor bleed to the afterburner that gave increased thrust at high speeds.
For the F/A-18, GE based the F404 on the YJ101 engine they had developed for the Northrop YF-17, enlarging the bypass ratio from 0.20 to 0.34 to enable higher fuel efficiency. The engine consists of a three-staged fan, seven axial stage compressor arrangement, single stage low and high pressure turbines, an augmentor, and produces maximum ...
To keep the F414 in the same envelope, or space occupied in the airframe, as the F404, the afterburner section was shortened by 4 in (10 cm) and the combustor shortened by 1 in (2.5 cm). Also changed from the F404 is the construction of the first three stages of the high-pressure compressor which are blisks rather than separate discs and ...
Thrust is increased from 3900 kN to 4200 kN (5750 kN to 6100 kN with afterburner), while fuel consumption is reduced by 2%, and service life of the engine is increased to 300 hours. [ 19 ] [ 20 ] However, the temperature of exhaust is also increased from 700 to 800 °C, accordingly when in operation the engine temperature is also increased by ...