Search results
Results from the WOW.Com Content Network
The level of the stimulus is automatically varied at a fixed rate. The subject is asked to press a button when the stimulus is detectable. Once the button is pressed, the level is automatically decreased by the motor-driven attenuator and increased when the button is not pushed. The threshold is thus tracked by the listeners, and calculated as ...
The level that can lead to hearing loss — when prolonged, he says — is lower, at 85 dB. ... allow sound to remain clear but at a quieter level — in other words, they don’t distort the ...
When sensorineural hearing loss (damage to the cochlea or in the brain) is present, the perception of loudness is altered. Sounds at low levels (often perceived by those without hearing loss as relatively quiet) are no longer audible to the hearing impaired, but sounds at high levels often are perceived as having the same loudness as they would for an unimpaired listener.
Quiet ($25): Up to 26 decibels SNR of noise reduction ... (NRR is typically 2 to 3 decibels lower than SNR). The higher the decibel level, the more noise reduction earplugs offer. For example ...
being approximately the lowest sound intensity hearable by an undamaged human ear under room conditions. The proper notations for sound intensity level using this reference are L I /(1 pW/m 2) or L I (re 1 pW/m 2), but the notations dB SIL, dB(SIL), dBSIL, or dB SIL are very common, even if they are not accepted by the SI. [6]
If you want to give white noise a try, Dr. Maddox recommends keeping it at a low decibel level and not blasting it all day, as playing white noise at high decibels can cause long-term issues with ...
Signal-to-noise ratio (SNR), however, is the ratio between the noise floor and an arbitrary reference level or alignment level. In "professional" recording equipment, this reference level is usually +4 dBu (IEC 60268-17), though sometimes 0 dBu (UK and Europe – EBU standard Alignment level).
Varying intensity levels can also have an effect on masking. The lower end of the filter becomes flatter with increasing decibel level, whereas the higher end becomes slightly steeper. Changes in slope of the high frequency side of the filter with intensity are less consistent than they are at low frequencies.