Search results
Results from the WOW.Com Content Network
In a centrifugal oil and water separator, the force of gravity is one-thousand [citation needed] times greater that of the coalescing plate pack separator or the petrol interceptor, so the separation is much greater. Not only is the force of separation greater, but there are fewer working parts so maintenance is much easier and cheaper.
Downhole oil–water separation (DOWS) technology is an emerging technology that separates oil and gas from produced water at the bottom of the well, and re-injects most of the produced water into another formation which is usually deeper than the producing formation, while the oil and gas rich stream is pumped to the surface.
A separator for petroleum production is a large vessel designed to separate production fluids into their constituent components of oil, gas and water. A separating vessel may be referred to in the following ways: Oil and gas separator, Separator, Stage separator, Trap, Knockout vessel (Knockout drum, knockout trap, water knockout, or liquid ...
Oil filtration systems generally use a multistage filtration with coarse and fine filters. [2] Centrifugation is separation of oil and water, or oil and solid particles by centrifugal forces. Vacuum treatment degasses and dehydrates industrial oil. This method is well suited for removing dispersed and dissolved water, as well as dissolved gases ...
Marine Oily water separator. A gravity plate separator contains a series of oleophilic plates through which the contaminated water flows. The oil in the water coalesces on the underside of the plate eventually forming droplets before coalescing into liquid oil which floats off the plates and accumulates at the top of the chamber.
In other DOWS systems, a separate pump is needed to inject the water-rich stream into a permeable zone. [5] An artificial lift pump is used to lift the petroleum-rich stream to the surface. [6] DOWS systems do not entirely separate petroleum from water in the borehole. Instead, DOWS systems will decrease the amount of water brought to the surface.
Here, the words "upstream" and "downstream" refer to before and after the liquid passes through the throttling valve or device. This type of flash evaporation is used in the desalination of brackish water or ocean water by "Multi-Stage Flash Distillation." The water is heated and then routed into a reduced-pressure flash evaporation "stage ...
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.