Search results
Results from the WOW.Com Content Network
In this case the lateral forces at the tire do not act at the center of the contact patch, but at a point behind the center. This distance is called the pneumatic trail and varies with speed, load, steer angle, surface, tire type, tire pressure and time. A good starting point for this is 30 mm behind the center of the contact patch. [citation ...
The diagram below shows the tire from above, so that the road surface lies in the xy-plane. The vehicle to which the tire is attached is moving in the positive y direction. In this example, the vehicle would be cornering to the right (i.e. the positive x direction points to the center of the corner).
Camber is the angle which the vertical axis of the wheel makes with the vertical axis of the vehicle. This angle is very important for the cornering performance of the vehicles. Generally, a Camber around 0.5-2 degrees is given on the vehicles. Depending upon wheel orientation, Camber can be of three types. 1. Positive Camber
Zero scrub radius (top) positive scrub radius (center) negative scrub radius (bottom) In an automobile's suspension system, the scrub radius is the distance in front view between the king pin axis and the center of the contact patch of the wheel, where both would theoretically touch the road. It can be positive, negative or zero.
The radial axis runs from the tire center toward the tread, and is the vertical axis running from the roadway through the tire center toward the vehicle. This axis supports the vehicle's weight. The lateral axis runs sideways across the tread. This axis is parallel to the tire mounting axle on the vehicle.
English: Diagram showing a side view and underside of a conventional 18-wheeler semi-trailer truck with an enclosed cargo space. The underside view shows the arrangement of the 18 tires (wheels). Shown in blue in the underside view are the axles, drive shaft, and differentials. The legend for labeled parts of the truck is as follows: tractor unit
A two-wheel drive vehicle has two driven wheels, typically both at the front or back, while a four-wheel drive has four. A steering wheel is a wheel that turns to change the direction of a vehicle. A trailer wheel is one that is neither a drive wheel, nor a steer wheel. Front-wheel drive vehicles typically have the rear wheels as trailer wheels.
In contrast to the MR layout, the center of mass of the engine is between the rear axle and the rear bumper. Although common in electric cars, [5] and in transit buses and coaches due to the elimination of the drive shaft with low-floor bus, this layout has become increasingly rare in fossil-fuelled passenger cars. The Porsche 911 is notable ...