enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drywall anchor - Wikipedia

   en.wikipedia.org/wiki/Drywall_anchor

   Expandable wall anchors with toggle arms. A drywall anchor, also known as a wall anchor, is an insert that, combined with the appropriate screw, can create a strong mount anywhere on a drywall panel or similar hollow wall. [1] A drywall anchor goes between the screw and the drywall, gripping the drywall much more effectively than a screw would. [2]

3. This Hack Will Ensure You ALWAYS Hit A Stud - AOL

   www.aol.com/lifestyle/hack-ensure-always-hit...

   The stud is simply a vertical two-by-four beam in the wall for structural support. And if you lost your stud finder in the moving boxes or simply don’t have one to begin with, these hacks will help.

4. Wall stud - Wikipedia

   en.wikipedia.org/wiki/Wall_stud

   Steel studs are gaining popularity as a non-combustible alternative, especially for non load-bearing walls, and are required in some firewalls. In New Zealand, the required lumber size and spacing of wall studs are determined using NZS 3604 Timber-framed buildings table 8.2 for loadbearing walls and table 8.4 for non-loadbearing walls. [4]

5. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]

6. Dwang - Wikipedia

   en.wikipedia.org/wiki/Dwang

   In construction, a dwang Scotland and New Zealand, [1] [2] [3] nogging piece, nogging, noggin or nog (all derived from brick nog) [4] [5] England and Australia, or blocking North America, is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.

7. Lath and plaster - Wikipedia

   en.wikipedia.org/wiki/Lath_and_plaster

   In use as early as 1900, rock lath (also known as "button board," "plaster board" or "gypsum-board lath"), is a type of gypsum wall board (essentially an early form of drywall) with holes spaced regularly to provide a 'key' for wet plaster. [3] Rock lath was typically produced in sheets sized 2 by 4 feet (610 by 1,220 mm).