enow.com Web Search

  1. Ads

    related to: conduit 45 degree elbow

Search results

  1. Results from the WOW.Com Content Network
  2. Street elbow - Wikipedia

    en.wikipedia.org/wiki/Street_elbow

    Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

  3. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    The key point is that the plumbing term focuses on the degree of bend from the original straight pipe, not the resulting angle. Elbows are also categorized by length. The radius of curvature of a long-radius (LR) elbow is 1.5 times the pipe diameter, but a short-radius (SR) elbow has a radius equal to the pipe diameter. Wide available short ...

  4. Cable tray - Wikipedia

    en.wikipedia.org/wiki/Cable_tray

    To maintain support of cables at changes of elevation or direction of a tray, a large number of specialized cable tray fittings are made compatible with each style and manufacturer. Horizontal elbows change direction of a tray in the same plane as the bottom of the tray and are made in 30, 45 and 90 degree forms; inside and outside elbows are ...

  5. JIC fitting - Wikipedia

    en.wikipedia.org/wiki/JIC_fitting

    JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.

  6. Electrical conduit - Wikipedia

    en.wikipedia.org/wiki/Electrical_conduit

    In addition to providing access to wires for pulling, "L" fittings allow a 90 degree turn in conduit where there is insufficient space for a full-radius 90 degree sweep (curved conduit section). T-shaped bodies ("Tees") feature an inlet in line with the access cover and outlets to both the cover's left and right.

  7. Flare fitting - Wikipedia

    en.wikipedia.org/wiki/Flare_fitting

    Flared fittings are an alternative to solder-type joints that are mechanically separable and doesn’t require an open flame. Copper tube used for propane, liquefied petroleum gas, or natural gas may use flared brass fittings of single 45°-flare type, according to NFPA 54/ANSI. Z223.1 National Fuel Gas Code.

  1. Ads

    related to: conduit 45 degree elbow