Search results
Results from the WOW.Com Content Network
The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to kilogram per cubic metre [kg/m3]. Mixed liquor is a combination of raw or unsettled wastewater or pre-settled wastewater and activated sludge within an aeration tank.
Alkalinity is typically reported as mg/L as CaCO 3. (The conjunction "as" is appropriate in this case because the alkalinity results from a mixture of ions but is reported "as if" all of this is due to CaCO 3.) This can be converted into milliequivalents per Liter (meq/L) by dividing by 50 (the approximate MW of CaCO 3 divided by 2).
1 mmol/L is equivalent to 100.09 mg/L CaCO 3 or 40.08 mg/L Ca 2+. A degree of General Hardness ( dGH or 'German degree' (°dH, deutsche Härte )) is defined as 10 mg/L CaO or 17.848 ppm. A Clark degree (°Clark) or English degree (°e or e) is defined as one grain (64.8 mg) of CaCO 3 per Imperial gallon (4.55 litres) of water, equivalent to 14. ...
Here are the conversion factors for those various expressions of wind speed: 1 m/s = 2.237 statute mile/h = 1.944 knots 1 knot = 1.151 statute mile/h = 0.514 m/s 1 statute mile/h = 0.869 knots = 0.447 m/s. Note: 1 statute mile = 5,280 feet = 1,609 meters
Densities using the following metric units all have exactly the same numerical value, one thousandth of the value in (kg/m 3). Liquid water has a density of about 1 kg/dm 3, making any of these SI units numerically convenient to use as most solids and liquids have densities between 0.1 and 20 kg/dm 3. kilogram per cubic decimetre (kg/dm 3)
Calcium and magnesium ions present as sulfates, chlorides, carbonates and bicarbonates cause water to be hard. Water chemists measure water impurities in parts per million (ppm).
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
This is equivalent to about ninety seconds out of one day. One part per ten thousand is denoted by the permyriad sign (‱). Although rarely used in science (ppm is typically used instead), one permyriad has an unambiguous value of one part per 10,000 (10 4) parts, and a value of 10 −4. This is equivalent to about nine seconds out of one day.