Search results
Results from the WOW.Com Content Network
Surveying with a chain is simple if the land is level and continuous—it is not physically practicable to range across large depressions or significant waterways, for example. On sloping land, the chain was to be "leveled" by raising one end as needed, so that undulations did not increase the apparent length of the side or the area of the ...
Rankine's method or tangential angle method is an angular technique for laying out circular curves by a combination of chaining and angles at circumference, fully exploiting the theodolite and making a substantial improvement in accuracy and productivity over existing methods. This method requires access to only one road/path of communication ...
Position resection and intersection are methods for determining an unknown geographic position (position finding) by measuring angles with respect to known positions.In resection, the one point with unknown coordinates is occupied and sightings are taken to the known points; in intersection, the two points with known coordinates are occupied and sightings are taken to the unknown point.
Traverse is a method in the field of surveying to establish control networks. [1] It is also used in geodesy. Traverse networks involve placing survey stations along a line or path of travel, and then using the previously surveyed points as a base for observing the next point.
The ordinary methods of surveying with a theodolite, chain, and levelling instrument are fairly satisfactory when the ground is relatively clear of obstructions and not very precipitous, but it becomes extremely cumbersome when the ground is covered with bush, or broken up by ravines. Chain measurements then become slow and liable to ...
In surveying, tape correction(s) refer(s) to correcting measurements for the effect of slope angle, expansion or contraction due to temperature, and the tape's sag, which varies with the applied tension.
Compass surveying is a type of surveying in which the directions of surveying lines are determined with a magnetic compass, and the length of the surveying lines are measured with a tape or chain or laser range finder. [2] The compass is generally used to run a traverse line. The compass calculates bearings of lines with respect to magnetic needle.
Pacing is a reasonably easy and quick method of measuring distance in the field. [1] It is used to measure a distance and is often used with a sighting or a hand compass. Most commonly, pacing is split up into segments, such as chains, which are set measures of distance. By determining one's own pace, distance can easily be estimated.