Search results
Results from the WOW.Com Content Network
Another method of reducing the fan speed [5] is by moving the 5 V wire in the classical Molex power connector in the place of the Ground wire going to the fan, thereby delivering +7 V (12 V − 5 V = 7 V) to the fan. However, this is a potentially risky method, because +5 V PSU line is intended to source current only, not sink it, so the PSU is ...
Since the value reported by PECI takes into account internal processor information about safe operating temperatures, it alleviates the need for the BIOS or operating system to make potentially incorrect assumptions about this limit. Furthermore, it supports dynamic fan control with a high degree of accuracy, where fan speed can be ...
In this case, the ergonomics of the system are improved because the fan is quieter, as it is controlled to rotate at a lower speed and does not change speed as often. However, when the temperature does cross the controller's threshold, it will take much longer to reduce the temperature to safe levels.
Where noise is an issue, larger, slower-turning fans are quieter than smaller, faster fans that can move the same airflow. Fan noise has been found to be roughly proportional to the fifth power of fan speed; halving the speed reduces the noise by about 15 dB. [22] Axial fans may rotate at speeds of up to around 38,000 rpm for smaller sizes. [23]
SpeedFan is a system monitor for Microsoft Windows that can read temperatures, voltages and fan speeds of computer components. [3] It can change computer fan speeds depending on the temperature of various components. [1] [4] The program can display system variables as charts and as an indicator in the system tray.
People who design digital integrated circuits typically insert trees whenever necessary such that the fan-in and fan-out of each and every gate on the chip is between 2 and 10. [1] Dynamic or AC fan-out, not DC fan-out is therefore the primary limiting factor in many practical cases, due to the speed limitation.
MAP sensor data can be converted to air mass data by using a second variable coming from an IAT Sensor (intake air temperature sensor). This is called the speed-density method. Engine speed (RPM) is also used to determine where on a look up table to determine fuelling, hence speed-density (engine speed / air density).
A fan-cooled heat sink on the processor of a personal computer. To the right is a smaller heat sink cooling another integrated circuit of the motherboard. Typical heatsink-fan combination found on a consumer laptop.