Search results
Results from the WOW.Com Content Network
A Queued Serial Peripheral Interface (QSPI; different to but has same abbreviation as Quad SPI described in § Quad SPI) is a type of SPI controller that uses a data queue to transfer data across an SPI bus. [19] It has a wrap-around mode allowing continuous transfers to and from the queue with only intermittent attention from the CPU.
The SPI 4.2 interface is composed of high speed clock, control, and data lines and lower speed FIFO buffer status lines. The high speed data line include a 16-bit data bus, a 1 bit control line and a double data rate (DDR) clock. The clock can run up to 500 MHz, supporting up to 1 GigaTransfer per second.
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
Ultra-640 (otherwise known as Fast-320) was promulgated as a standard (INCITS 367-2003 or SPI-5) in early 2003. It doubles the interface speed yet again, this time to 640 MB/s. Ultra-640 pushes the limits of LVD signaling; the speed limits cable lengths drastically, making it impractical for more than one or two devices.
A typical application of SPI-4.2 is to connect a framer device to a network processor. It has been widely adopted by the high speed networking marketplace. The interface consists of (per direction): sixteen LVDS pairs for the data path; one LVDS pair for control; one LVDS pair for clock at half of the data rate
To reduce the number of pins in a package, many ICs use a serial bus to transfer data when speed is not important. Some examples of such low-cost lower-speed serial buses include RS-232, DALI, SPI, CAN bus, I²C, UNI/O, and 1-Wire. Higher-speed serial buses include USB, SATA and PCI Express.
Maximum standard speed of both of the 2692's channels is 115.2 kbit/s. The 26C92 is an upwardly compatible version of the 2692, with 8-byte transmitter and receiver FIFOs for improved performance during continuous bi-directional asynchronous transmission (CBAT) on both channels at the maximum standard speed of 230.4 kbit/s.
Low Pin Count interface Winbond chip Trusted Platform Module installed on a motherboard, and using the LPC bus. The Low Pin Count (LPC) bus is a computer bus used on IBM-compatible personal computers to connect low-bandwidth devices to the CPU, such as the BIOS ROM (BIOS ROM was moved to the Serial Peripheral Interface (SPI) bus in 2006 [1]), "legacy" I/O devices (integrated into Super I/O ...