Search results
Results from the WOW.Com Content Network
When the hopper is full (8 to 34 m 3 or 10 to 44 cu yd heaped, depending on type) it is raised, and closed with a vertical blade (known as the apron). The scraper can transport its load to the fill area where the blade is raised, the back panel of the hopper, or the ejector, is hydraulically pushed forward and the load tumbles out.
The scraper in the center of the image is a three corner scraper and is typically used to deburr holes or the internal surface of bush-type bearings. Bushes are typically made from bronze or a white metal. The scraper pictured at the bottom is a curved scraper. It has a slight curve in its profile and is also suitable for bush bearings ...
A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.
The M9 armored combat earthmover (ACE) is a highly mobile armored tracked vehicle that provides combat engineer support to frontline forces. Fielded by the United States Marine Corps, and the United States Army, its tasks include eliminating enemy obstacles, maintenance and repair of roads and supply routes, and construction of fighting positions.
A pinch point bar has a chisel at one end. Bars are typically 5 to 6 ft (1.5 to 1.8 m) long and weigh 15 to 23 lb (6.8 to 10.4 kg). They are usually made entirely of cylindrical or hexagonal forged steel with a diameter of approximately 1 in (2.5 cm). Chisel and wedge ends typically have a blade width measuring 1 to 3 in (3 to 8 cm).
Three-point linkage on a Ferguson 35 tractor. The tractor and linkage are painted gold. The grey bars are a separate implement (a towing ball hitch) attached to the linkage. The three-point hitch is made up of several components working together. These include the tractor's hydraulic system, attaching points, the lifting arms, and stabilizers.
The process begins with three square plates each given an identification (ex., 1,2 and 3). The first step is to rub plates 1 and 2 together with a marking medium (called bluing today) revealing the high spots which would be removed by hand scraping with a steel scraper, until no irregularities were visible.
They are suited to sharpening saw blades and dressing tool edges, especially where a finer, sharper edge or smoother surface finish is desired. The Chainsaw file is one example, used primarily for sharpening chainsaws. These appear to have a round cross-section, but are actually shaped to fit snugly against the cutting edge of a chainsaw's teeth.