Search results
Results from the WOW.Com Content Network
This article describes the graphic conventions used in Sectional charts and Terminal area charts published for aeronautical navigation under Visual Flight Rules in the United States of America. The charts are published "in accordance with Interagency Air Cartographic Committee specifications and agreements, approved by the Department of Defense ...
An aeronautical chart is a map designed to assist in the navigation of aircraft, much as nautical charts do for watercraft, or a roadmap does for drivers. Using these charts and other tools, pilots are able to determine their position, safe altitude, best route to a destination, navigation aids along the way, alternative landing areas in case of an in-flight emergency, and other useful ...
The first sectional chart was published in 1930; in 1937 the full series of the lower 48 states was completed. These early sectional charts were smaller (most covered two degrees of latitude and six of longitude) with the map on one side; after 1950 the legend and index to adjoining charts was on the reverse.
FAA-Terminal Area Chart Baltimore-Washington from 2011. Like the VFR sectional charts that they complement, terminal area charts depict topographic features and other information of interest to aviators flying visually, including major landmarks, terrain elevations, visual navigation routes, ground-based navigation aids, airports, rivers, cities, and airspace boundaries.
A World Aeronautical Chart (WAC) was a type of aeronautical chart used for navigation by pilots of moderate speed aircraft and aircraft at high altitudes in the United States. They are at a scale of 1:1,000,000 (about 1 inch = 13.7 nautical miles or 16 statute miles). WACs were discontinued by the Federal Aviation Administration (FAA) in 2015.
This instrument flight rules chart shows low-altitude airways in the Oakland Area Control Center (near San Francisco, California). In the United States, airways [1] or air routes are defined by the Federal Aviation Administration (FAA) in two ways: "VOR Federal airways and Low/Medium Frequency (L/MF) (Colored) Federal airways" [2]
Aeronautical chart on Lambert conformal conic projection with standard parallels at 33°N and 45°N. A Lambert conformal conic projection ( LCC ) is a conic map projection used for aeronautical charts , portions of the State Plane Coordinate System , and many national and regional mapping systems.
Aeronautical chart conventions (United States) S. ... World aeronautical chart This page was last edited on 10 February 2023, at 03:35 (UTC). ...