Search results
Results from the WOW.Com Content Network
A manual transmission (MT), also known as manual gearbox, standard transmission (in Canada, the United Kingdom and the United States), or stick shift (in the United States), is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch (which is usually ...
Preselector gearboxes were most common prior to the widespread adoption of the automatic transmission, so they were considered in comparison to the "crash gearbox" type of manual transmission. Preselector gearboxes were often marketed as "self-changing" gearboxes, [ 1 ] however this is an inaccurate description as the driver is required to ...
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
A cone clutch serves the same purpose as a disk or plate clutch; however, instead of mating two spinning disks, the cone clutch uses two conical surfaces to transmit torque by friction. [ 1 ] The cone clutch transfers a higher torque than plate or disk clutches of the same size due to the wedging action and increased surface area.
This is an accepted version of this page This is the latest accepted revision, reviewed on 20 January 2025. Mechanical device that connects and disconnects two rotating shafts or other moving parts For other uses, see Clutch (disambiguation). Friction disk for a dry clutch A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. The clutch's ...
Automated manual transmissions can be semi-automatic or fully-automatic in operation. Several different systems to automate the clutch and/or shifting have been used over the years, but they will generally use one of the following methods of actuation for the clutch and/or shifting: hydraulic or electro-hydraulic actuation, [12] electro-mechanical, [13] pneumatic, [6] [14] [15] electromagnetic ...
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
Borg-Warner R-11 overdrive - 3-speed manual transmission with electric overdrive Ford used them up until 1975 in trucks. Borg-Warner T-50 transmission — 5-speed longitudinal manual - used by GM in its RWD H-Body cars and a few other limited light duty applications from 1976 to 1978;