Search results
Results from the WOW.Com Content Network
The nominal impedance of the transmission line and of the amplifiers and equalisers in the transmission chain will all be the same value. [6] Nominal impedance is used, however, to characterise the transducers of an audio system, such as its microphones and loudspeakers. It is important that these are connected to a circuit capable of dealing ...
The electrical impedance of the speaker varies with the back EMF and thus with the applied frequency. The impedance is at its maximum at F s, shown as Z max in the graph. For frequencies just below resonance, the impedance rises rapidly as the frequency increases towards F s and is inductive in nature.
A loudspeaker with an 8Ω nominal impedance may exhibit actual impedances ranging from approximately 5 to 100Ω depending on frequency. In this context, the nominal wattage is the theoretical electric power that would be transferred from amplifier to speaker if the loudspeaker was actually exhibiting its nominal impedance. The actual electric ...
The loudspeaker's nominal load impedance (input impedance) of is usually around 4 to 8 Ω, although other impedance speakers are available, sometimes dropping as low as 1 Ω or 2 Ω. However, the impedance rating of a loudspeaker is simply a number that indicates the nominal minimum impedance of that loudspeaker over a representative portion of ...
A speaker with a higher impedance may have lower measured sensitivity and thus appear to be less efficient than a speaker with a lower impedance even though their efficiencies are actually similar. Speaker efficiency is a metric that only measures the actual percentage of electrical power that the speaker converts to acoustic power and is ...
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
The main effect of is on the impedance of the driver, with high drivers displaying a higher impedance peak. One predictor for low Q m s {\displaystyle Q_{\rm {ms}}} is a metallic voice-coil former. These act as eddy-current brakes and increase damping, reducing Q m s {\displaystyle Q_{\rm {ms}}} .
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...