Search results
Results from the WOW.Com Content Network
In the case of a water softener, the cation exchange resin is exchanging sodium (the Na + ion of NaCl) for hardness minerals such as calcium and magnesium. A dealkalizer contains strong base anion exchange resin that exchanges chloride (the Cl – ion of the NaCl) for carbonate (CO − 3), bicarbonate (H C O − 3) and sulfate (SO 2− 4). As ...
For example, in a solution with a 1:5 dilution ratio, entails combining 1 unit volume of solute (the material to be diluted) with 5 unit volumes of the solvent to give 6 total units of total volume. In photographic development, dilutions are normally given in a '1+x' format.
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
A study found the mean concentration of sodium in softened water to be 278 mg/L. [24] In 2 liters of water—the amount of drinking water typically suggested for an average adult, this constitutes about 22% of the recommended sodium intake by the US CDC and may make a difference to those who need to significantly limit their sodium consumption.
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
inhaled osmium tetroxide is immediately dangerous to life or health (1 mg Os/m 3) [13] 10 −8: 10 −7: 101 nM: hydronium and hydroxide ions in pure water at 25 °C (pK W = 13.99) [14] 10 −6: μM: 10 −5: 10 −4: 180–480 μM: normal range for uric acid in blood [10] 570 μM: inhaled carbon monoxide induces unconsciousness in 2–3 ...
The following chart shows the solubility of various ionic compounds in water at 1 atm pressure and room temperature (approx. 25 °C, 298.15 K). "Soluble" means the ionic compound doesn't precipitate, while "slightly soluble" and "insoluble" mean that a solid will precipitate; "slightly soluble" compounds like calcium sulfate may require heat to precipitate.
The quantity "1 ppm" can be used for a mass fraction if a water-borne pollutant is present at one-millionth of a gram per gram of sample solution. When working with aqueous solutions, it is common to assume that the density of water is 1.00 g/mL. Therefore, it is common to equate 1 kilogram of water with 1 L of water.