Search results
Results from the WOW.Com Content Network
In the case of a water softener, the cation exchange resin is exchanging sodium (the Na + ion of NaCl) for hardness minerals such as calcium and magnesium. A dealkalizer contains strong base anion exchange resin that exchanges chloride (the Cl – ion of the NaCl) for carbonate (CO − 3), bicarbonate (H C O − 3) and sulfate (SO 2− 4). As ...
A study found the mean concentration of sodium in softened water to be 278 mg/L. [24] In 2 liters of water—the amount of drinking water typically suggested for an average adult, this constitutes about 22% of the recommended sodium intake by the US CDC and may make a difference to those who need to significantly limit their sodium consumption.
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
inhaled osmium tetroxide is immediately dangerous to life or health (1 mg Os/m 3) [13] 10 −8: 10 −7: 101 nM: hydronium and hydroxide ions in pure water at 25 °C (pK W = 13.99) [14] 10 −6: μM: 10 −5: 10 −4: 180–480 μM: normal range for uric acid in blood [10] 570 μM: inhaled carbon monoxide induces unconsciousness in 2–3 ...
For example, the freezing point of water is 0 °C and 32 °F, and a 5 °C change is the same as a 9 °F change. Thus, to convert from units of Fahrenheit to units of Celsius, one subtracts 32 °F (the offset from the point of reference), divides by 9 °F and multiplies by 5 °C (scales by the ratio of units), and adds 0 °C (the offset from the ...
3 in solution represents 1 molar equivalent, while 1 mole of CO 2− 3 is 2 molar equivalents because twice as many H + ions would be necessary to balance the charge. The total charge of a solution always equals zero. [8] This leads to a parallel definition of alkalinity that is based upon the charge balance of ions in a solution.
The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to kilogram per cubic metre [kg/m3]. Mixed liquor is a combination of raw or unsettled wastewater or pre-settled wastewater and activated sludge within an aeration tank.