enow.com Web Search

  1. Ads

    related to: how to test a coil for spark

Search results

  1. Results from the WOW.Com Content Network
  2. Induction coil - Wikipedia

    en.wikipedia.org/wiki/Induction_coil

    For this reason, induction coils were called spark coils. An induction coil is traditionally characterised by the length of spark it can produce; a '4 inch' (10 cm) induction coil could produce a 4 inch spark. Until the development of the cathode ray oscilloscope, this was the most reliable measurement of peak voltage of such asymmetric ...

  3. Spark testing - Wikipedia

    en.wikipedia.org/wiki/Spark_testing

    Spark testing of tool steel Spark testing of mild steel. Spark testing is a method of determining the general classification of ferrous materials. It normally entails taking a piece of metal, usually scrap, and applying it to a grinding wheel in order to observe the sparks emitted. [1]

  4. Ignition coil - Wikipedia

    en.wikipedia.org/wiki/Ignition_coil

    An ignition coil is used in the ignition system of a spark-ignition engine to transform the battery voltage to the much higher voltages required to operate the spark plug(s). The spark plugs then use this burst of high-voltage electricity to ignite the air-fuel mixture. The ignition coil is constructed of two sets of coils wound around an iron ...

  5. Capacitor discharge ignition - Wikipedia

    en.wikipedia.org/wiki/Capacitor_discharge_ignition

    The discharge capacitor within the CD ignition had the ability to provide a powerful spark in excess of 4 times the spark power of the Kettering system using the same coil, with the exception that spark energy could be maintained at high rpm unlike the Kettering system. The Hyland unit consumed only four amperes at 5000rpm (8cyl) or 10,000rpm ...

  6. Ignition system - Wikipedia

    en.wikipedia.org/wiki/Ignition_system

    A variation coil-on-plug ignition has each coil handle two plugs, on cylinders which are 360 degrees out of phase (and therefore reach top dead center (TDC) at the same time); in the four-cycle engine this means that one plug will be sparking during the end of the exhaust stroke while the other fires at the usual time, a so-called "wasted spark ...

  7. Wasted spark system - Wikipedia

    en.wikipedia.org/wiki/Wasted_spark_system

    A wasted spark system is a type of ignition system used in some four-stroke cycle internal combustion engines. In a wasted spark system, the spark plugs fire in pairs, with one plug in a cylinder on its compression stroke and the other plug in a cylinder on its exhaust stroke. The extra spark during the exhaust stroke has no effect and is thus ...

  8. Ignition magneto - Wikipedia

    en.wikipedia.org/wiki/Ignition_magneto

    Voltage across the primary coil results in a proportional voltage being induced across the secondary winding of the coil. The turns ratio between the primary and secondary coil is selected so that the voltage across the secondary reaches a very high value, enough to arc across the gap of the spark plug.

  9. Ignition timing - Wikipedia

    en.wikipedia.org/wiki/Ignition_timing

    Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.

  1. Ads

    related to: how to test a coil for spark