Search results
Results from the WOW.Com Content Network
If the circuit being measured can support the heating current, then it is possible to make a post-measurement calculation to correct the effect, as the impedance of the heating element is known. If the signal is small then a pre-amplifier is necessary, and the measuring capabilities of the instrument will be limited by this pre-amplifier.
A tachometer (revolution-counter, tach, rev-counter, RPM gauge) is an instrument measuring the rotation speed of a shaft or disk, as in a motor or other machine. [1] The device usually displays the revolutions per minute (RPM) on a calibrated analogue dial, but digital displays are increasingly common.
For example, if the meter is set to a range of 300 V full scale, the meter's impedance will be 6 MΩ. 20,000 Ω/V is the best (highest) sensitivity available for typical analog multimeters that lack internal amplifiers. For meters that do have internal amplifiers (VTVMs, FETVMs, etc.), the input impedance is fixed by the amplifier circuit.
Using a PMU, it is simple to detect abnormal waveform shapes. A waveform shape described mathematically is called a phasor.. A phasor measurement unit (PMU) is a device used to estimate the magnitude and phase angle of an electrical phasor quantity (such as voltage or current) in the electricity grid using a common time source for synchronization.
The Low Voltage Series include the MSP430C09x and MSP430L092 parts, capable of running at 0.9 V. These 2 series of low voltage 16-bit microcontrollers have configurations with two 16-bit timers, an 8-bit analog-to-digital (A/D) converter, an 8-bit digital-to-analog (D/A) converter, and up to 11 I/O pins.
Delay calculation is the term used in integrated circuit design for the calculation of the gate delay of a single logic gate and the wires attached to it. By contrast, static timing analysis computes the delays of entire paths, using delay calculation to determine the delay of each gate and wire.
[6] [7] As the name "Magnum" implies, it was a fairly large device at 4.5 inches in diameter—about 1.5 inches more than Fowler's average non-Magnum-series calculators. [8] The large design meant that much larger calculations could be performed on it, "to four, and sometimes five, significant figures," according to the instruction manual. [6]
A partially disassembled Curta calculator, showing the digit slides and the stepped drum behind them Curta Type I calculator, top view Curta Type I calculator, bottom view. The Curta is a hand-held mechanical calculator designed by Curt Herzstark. [1] It is known for its extremely compact design: a small cylinder that fits in the palm of the hand.