enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Snips - Wikipedia

   en.wikipedia.org/wiki/Snips

   Snips, also known as shears, are hand tools used to cut sheet metal and other tough webs. It is a cutting tool. Workers use various types of snips, with the cutting edges being straight or curved to various degrees. The style of edge employed will depend if a straight sheer or some type of shapes cut is necessary.

3. Types of press tools - Wikipedia

   en.wikipedia.org/wiki/Types_of_press_tools

   Die Back Plate:This plate prevents the hardened Die inserts penetrating into bottom plate. Guide Pillar & Guide Bush : Used for alignment between top and bottom halves of the press tools. Bottom plate:It is used to hold bottom half of the press tool with press slide. Stripper plate: it is used to strip off the component from punches.

4. Shear (sheet metal) - Wikipedia

   en.wikipedia.org/wiki/Shear_(sheet_metal)

   Large versions can cut sheet metal up to 12 gauge. [5] An alternative to the hand tools are hydraulically powered tools attached to heavy machinery. They are usually used to cut materials that are too bulky to be transported to a cutting facility, too big or dangerous for the hand tools and are stored at remote locations (e.g. mines, forests). [6]

5. Broaching (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Broaching_(metalworking)

   Broaching is a machining process that uses a toothed tool, called a broach, to remove material.There are two main types of broaching: linear and rotary.In linear broaching, which is the more common process, the broach is run linearly against a surface of the workpiece to produce the cut.

6. File (tool) - Wikipedia

   en.wikipedia.org/wiki/File_(tool)

   A single-cut file has one set of parallel teeth while a cross-cut or double-cut file has a second set of cuts forming diamond shaped cutting surfaces. [1] In Swiss-pattern files the teeth are cut at a shallower angle, and are graded by number, with a number 1 file being coarser than a number 2, etc.

7. Chisel - Wikipedia

   en.wikipedia.org/wiki/Chisel

   The cross cut chisel is used for cutting grooves and slots. The blade narrows behind the cutting edge to provide clearance. The round nose chisel is used for cutting semi-circular grooves for oil ways in bearings. The diamond point chisel is used for cleaning out corners or difficult places and pulling over centre punch marks wrongly placed for ...

8. Always Score Your License Plate Sticker with a Razor ... - AOL

   www.aol.com/always-score-license-plate-sticker...

   Next, place the new sticker on the plate and smooth out any air bubbles. Finally, use a box cutter or other sharp tool to cut an X pattern on the sticker. Other patterns will work as well, but ...

9. Burr (edge) - Wikipedia

   en.wikipedia.org/wiki/Burr_(edge)

   Metal burr extending beyond the edge of the cut piece, view on the cut face (top) and from the bottom (bottom) A burr is a raised edge or small piece of material that remains attached to a workpiece after a modification process. [1] It is usually an unwanted piece of material and is removed with a deburring tool in a process called deburring.