Search results
Results from the WOW.Com Content Network
The suspension system of the B3 utilised a mixture of in-house developed components and BMW components. The coupé and cabriolet version used the shocks from the 335i Sport while the Saloon and Wagon variants used the shocks as found on the standard 335i. The coil springs as found on the 335i Sport are used throughout the B3 versions.
The E93's side windows are 30 per cent larger than its E46 convertible predecessor, resulting in a 38 per cent increase in visibility. [28] The BMW 3 Series convertible was often priced higher than direct rivals, however reviewers have praised its passenger/boot space (even with the roof down), driving dynamics, weight and chassis rigidity.
In 2004, the 3 Series Compact was replaced by the 1 Series which encompassed 3-door and 5-door hatchback, coupé and convertible body styles (the coupé and convertible models have been marketed separately as the 2 Series since 2014) as BMW's entry-level cars; a new nameplate was created since the 1 Series is smaller than the contemporary 3 ...
On introduction in 1982, the E30 was produced solely in the 2-door sedan body style. Four-door sedan models were introduced in 1983, convertibles were introduced in 1985 and estate ("Touring") models were introduced in 1987. The E30 was the first 3 Series to be available in wagon and 4-door sedan body styles.
Full coilovers are matched up with a shock absorber from the factory, while with slip-on coilovers, the dampers and springs are bought separately and then assembled. [4] There are a large number of companies who make aftermarket coilovers for vehicles, many of which allow the customer to adjust various settings such as ride height and damping.
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
In 1995, the B8 was released. The B8 4.6 was based on the 4 litre V8 from the E34 5-series, put into a 328i-based shell. BMW V8s had coated bores which meant new blocks had to be cast by BMW specifically for Alpina V8s.
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.