Search results
Results from the WOW.Com Content Network
New polished concrete slab. The mix design of the concrete should be 3500 psi or higher. The concrete should be poured full depth to take advantage of the concrete's full structural strength, and also help to prevent cracks. The concrete should always be professionally finished with power trowels and cured with water for seven days. Polishing ...
Zinc phosphate was the very first dental cement to appear on the dental marketplace and is seen as the “standard” for other dental cements to be compared to. The many uses of this cement include permanent cementation of crowns, orthodontic appliances, intraoral splints, inlays, post systems, and fixed partial dentures.
MTA's design is based on Portland cement, but is not interchangeable with Portland cement construction materials. [4] It has been contrasted with Portland cement in studies. [1] Newly developed fast-set MTAs were developed based on pozzolan cement or zeolite cement. They use the pozzolanic reaction to improve the material. [clarification needed]
Autopolymerised cement is proven to be the most radiolucent among all resin cements, [11] making it relatively difficult to be seen on radiographs. Light-cured resin cements [1] Due to the presence of light-activated components (photo-initiators), this type of resin cement requires an external light source to initiate the setting reaction. This ...
A higher ratio gives a too fluid concrete mix resulting in a too porous hardened concrete of poor quality. Often, the concept also refers to the ratio of water to cementitious materials, w/cm. Cementitious materials include cement and supplementary cementitious materials such as ground granulated blast-furnace slag (GGBFS), fly ash (FA), silica ...
The addition of a small amount of sand will increase the strength. The mixture has a water-to-cement ratio of 0.28 to 0.40 with a void content of 15 to 25 percent. [8] The correct quantity of water in the concrete is critical. A low water to cement ratio will increase the strength of the concrete, but too little water may cause surface failure.
The ultimate strength of concrete is influenced by the water-cementitious ratio (w/cm), the design constituents, and the mixing, placement and curing methods employed.All things being equal, concrete with a lower water-cement (cementitious) ratio makes a stronger concrete than that with a higher ratio. [2]
ZOE can be used as a dental filling material or dental cement in dentistry. [ 1 ] [ 2 ] It is often used in dentistry when the decay is very deep or very close to the nerve or pulp chamber. Because the tissue inside the tooth, i.e. the pulp , reacts badly to the drilling stimulus (heat and vibration), it frequently becomes severely inflamed and ...