Search results
Results from the WOW.Com Content Network
RIPng (RIP next generation) is an extension of RIPv2 for support of IPv6, the next generation Internet Protocol. [12] The main differences between RIPv2 and RIPng are: Support of IPv6 networking. While RIPv2 supports RIPv1 updates authentication, RIPng does not. IPv6 routers were, at the time, supposed to use IPsec for authentication. [citation ...
The oldest routing protocol, and the oldest distance-vector protocol, is version 1 of the Routing Information Protocol (RIPv1). RIPv1 was formally standardised in 1988. [2] It establishes the shortest path across a network purely on the basis of the hops, that is numbers of routers that need to be passed to reach the destination network.
A routing protocol specifies how routers communicate with each other to distribute information that enables them to select paths between nodes on a computer network. Routers perform the traffic directing functions on the Internet; data packets are forwarded through the networks of the internet from router to router until they reach their ...
An interior gateway protocol (IGP) or interior routing protocol is a type of routing protocol used for exchanging routing table information between gateways (commonly routers) within an autonomous system (for example, a system of corporate local area networks). [1] This routing information can then be used to route network-layer protocols like IP.
A multicast routing protocol is a mechanism for constructing a loop-free shortest path from a source host that sends data to the multiple destinations that receives the data. IPv4 uses Class D address (224.0.0.0 ~ 239.255.255.255) [ 2 ] IPv6 multicast provides the previous feature of IPv4 and a new IPv6 feature, allowing a host to send a single ...
This difference shows up in the initial behavior and mechanisms of the two protocols. Dense Mode uses a fairly simple approach to handle IP multicast routing. The source initially broadcasts to every router directly connected to it. These neighboring routers further forward the data to their neighbors.
The link-state protocol is performed by every switching node in the network (i.e., nodes which are prepared to forward packets; in the Internet, these are called routers). [3] The basic concept of link-state routing is that every node constructs a map of the connectivity to the network in the form of a graph , showing which nodes are connected ...
The services and protocols specified in IEEE 802 map to the lower two layers (data link and physical) of the seven-layer Open Systems Interconnection (OSI) networking reference model. IEEE 802 divides the OSI data link layer into two sub-layers: logical link control (LLC) and medium access control (MAC), as follows: Data link layer. LLC sublayer