enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Multiway switching - Wikipedia

   en.wikipedia.org/wiki/Multiway_switching

   In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.

3. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.

4. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   A fibre washer (which expands when wet, aiding the seal) is used between the connector and the tap tail. Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size.

5. Automatic faucet - Wikipedia

   en.wikipedia.org/wiki/Automatic_faucet

   An automatic faucet or tap (also hands-free faucet, touchless faucet, electronic faucet, motion-sensing faucet, sensor faucet, or infrared faucet) is a faucet equipped with a proximity sensor and mechanism that opens its valve to allow water to flow in response to the presence of a user's hands in close proximity. The faucet closes its valve ...

6. Low-flow fixtures - Wikipedia

   en.wikipedia.org/wiki/Low-flow_fixtures

   Kitchen and bathroom faucets were limited to a flow rate of 2.2 gpm (gallons per minute) at 60 psi, and residential shower heads were limited to a flowrate of 2.5 gpm at 80 psi. [ 3 ] In response to an increasing number of water shortages and increased water utility rates there has been recent legislation by many states leading the way in water ...

7. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   The key to a functional island fixture vent is that the top elbow must be at least as high as the "flood level" (the peak possible drain water level in the sink), allowing it to serve as a de facto vacuum breaker preventing the loop from becoming a siphon for an overfilled sink, as from a clogged drain (rather than vent) line.

8. Fixture unit - Wikipedia

   en.wikipedia.org/wiki/Fixture_unit

   A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste water. Different fixtures have different flow requirements.

9. Isolation valve - Wikipedia

   en.wikipedia.org/wiki/Isolation_valve

   An isolation valve is a valve in a fluid handling system that stops the flow of process media to a given location, usually for maintenance or safety purposes. [1] They can also be used to provide flow logic (selecting one flow path versus another), and to connect external equipment to a system. [ 2 ]