Search results
Results from the WOW.Com Content Network
There is a short lag between the fuel being injected and combustion starting. [citation needed] By this time there is already a quantity of fuel in the combustion chamber which will ignite first in areas of greater oxygen density prior to the combustion of the complete charge. This sudden increase in pressure and temperature causes the ...
Low-speed pre-ignition (LSPI), also known as stochastic pre-ignition (SPI), [1] is a pre-ignition event that occurs in gasoline vehicle engines when there is a premature ignition of the main fuel charge. [2] LSPI is most common in certain turbocharged direct-injection vehicles operating in low-speed and high-load driving conditions. [3]
The fuel-characteristics of a particular gasoline-blend, which will resist igniting too early are measured as the octane rating of the fuel blend. Gasoline blends with stable octane ratings are produced in several fuel-grades for various types of motors. A low octane rated fuel may cause engine knocking and reduced efficiency in reciprocating ...
In the U.S., where tetraethyllead had been blended with gasoline (primarily to boost octane levels) since the early 1920s, standards to phase out leaded gasoline were first implemented in 1973. In 1995, leaded fuel accounted for only 0.6% of total gasoline sales and less than 2,000 tons of lead per year.
Higher compression ratios necessarily add parasitic load to the engine, and are only necessary if the engine is being specifically designed to run on high-octane fuel. Aircraft engines run at relatively low speeds and are "undersquare". They run best on lower-octane, slower-burning fuels that require less heat and a lower compression ratio for ...
With early induction and ignition systems the compression ratios had to be kept low. With advances in fuel technology and combustion management, high-performance engines can run reliably at 12:1 ratio. With low octane fuel, a problem would occur as the compression ratio increased as the fuel was igniting due to the rise in temperature that ...
Dr. A. Thomas McLellan, the co-founder of the Treatment Research Institute, echoed that point. “Here’s the problem,” he said. Treatment methods were determined “before anybody really understood the science of addiction. We started off with the wrong model.” For families, the result can be frustrating and an expensive failure.
A lean fuel mixture or excessive amount of oxygen in the combustion chamber; An engine that is running hotter than normal due to a cooling system problem (low coolant level, slipping fan clutch, inoperative electric cooling fan or other cooling system problem) Auto-ignition of engine oil droplets (Can be solved by using an oil catch tank) [3]