enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Inch - Wikipedia

   en.wikipedia.org/wiki/Inch

   Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as ⁠2 + 3 / 8 ⁠ ″ and not as 2.375″ nor as ⁠2 + 6 / 16 ⁠ ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...

3. Help:Convert - Wikipedia

   en.wikipedia.org/wiki/Help:Convert

   H:CON. Template { {convert}} is used to convert a value from one unit of measurement to another. This page provides an overview of the options available when using the template. See the documentation at Template:Convert for further details. Help:Convert units • Simplified list of some commonly used units.

4. Fraction - Wikipedia

   en.wikipedia.org/wiki/Fraction

   A simple fraction (also known as a common fraction or vulgar fraction, where vulgar is Latin for "common") is a rational number written as a / b or ⁠ ⁠, where a and b are both integers. [9] As with other fractions, the denominator (b) cannot be zero. Examples include ⁠ 1 2 ⁠, − ⁠ 8 5 ⁠, ⁠ −8 5 ⁠, and ⁠ 8 −5 ⁠.

5. Traditional French units of measurement - Wikipedia

   en.wikipedia.org/wiki/Traditional_French_units...

   Table of length units. 1⁄12 of a ligne. This unit is usually called the Truchet point in English. Prior to the French Revolution the Fournier point was also in use. It was 1⁄6 of a ligne or 1⁄864 of the smaller French foot. 1⁄12 of a pouce. This corresponds to the line, a traditional English unit. 1⁄12 of a pied du roi.

6. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

7. Imperial units - Wikipedia

   en.wikipedia.org/wiki/Imperial_units

   The former Weights and Measures office in Seven Sisters, London (590 Seven Sisters Road). The imperial system of units, imperial system or imperial units (also known as British Imperial [1] or Exchequer Standards of 1826) is the system of units first defined in the British Weights and Measures Act 1824 and continued to be developed through a series of Weights and Measures Acts and amendments.