Search results
Results from the WOW.Com Content Network
Approximating a fraction by a fractional decimal number: 5 / 3 1.6667: 4 decimal places: Approximating a fractional decimal number by one with fewer digits 2.1784: 2.18 2 decimal places Approximating a decimal integer by an integer with more trailing zeros 23217: 23200: 3 significant figures Approximating a large decimal integer using ...
Round duct support rings are spaced, often at three diameters, or as require at up to about 50 ft centers (14 m). At this spacing the main support rings are designed for the sum of suction pressure stresses & support bending moments. Round ductwork allowable compressive stress is = 662 /(d/t) +339 * Fy (tubular steel structures, chapter 2).
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]
Here the 'IEEE 754 double value' resulting of the 15 bit figure is 3.330560653658221E-15, which is rounded by Excel for the 'user interface' to 15 digits 3.33056065365822E-15, and then displayed with 30 decimals digits gets one 'fake zero' added, thus the 'binary' and 'decimal' values in the sample are identical only in display, the values ...
A fixed-point representation of a fractional number is essentially an integer that is to be implicitly multiplied by a fixed scaling factor. For example, the value 1.23 can be stored in a variable as the integer value 1230 with implicit scaling factor of 1/1000 (meaning that the last 3 decimal digits are implicitly assumed to be a decimal fraction), and the value 1 230 000 can be represented ...
For example, in duodecimal, 1 / 2 = 0.6, 1 / 3 = 0.4, 1 / 4 = 0.3 and 1 / 6 = 0.2 all terminate; 1 / 5 = 0. 2497 repeats with period length 4, in contrast with the equivalent decimal expansion of 0.2; 1 / 7 = 0. 186A35 has period 6 in duodecimal, just as it does in decimal. If b is an integer base ...
Example for the DIN ISO 2768-2 tolerance table. This is just one example for linear tolerances for a 100 mm value. This is just one of the 8 defined ranges (30–120 mm). Engineering tolerance is the permissible limit or limits of variation in: a physical dimension;
For example, if a ruler's smallest mark is 0.1 cm, and 4.5 cm is read, then it is 4.5 (±0.1 cm) or 4.4 cm to 4.6 cm as to the smallest mark interval. However, in practice a measurement can usually be estimated by eye to closer than the interval between the ruler's smallest mark, e.g. in the above case it might be estimated as between 4.51 cm ...