Search results
Results from the WOW.Com Content Network
A plate-fin heat exchanger is made of layers of corrugated sheets separated by flat metal plates, typically aluminium, to create a series of finned chambers. Separate hot and cold fluid streams flow through alternating layers of the heat exchanger and are enclosed at the edges by side bars. Principal Components of a Plate Fin Heat Exchanger
Conceptual diagram of a plate and frame heat exchanger A single plate heat exchanger An interchangeable plate heat exchanger directly applied to the system of a swimming pool. Another type of heat exchanger is the plate heat exchanger. These exchangers are composed of many thin, slightly separated plates that have very large surface areas and ...
The high heat transfer efficiency for such a small physical size has increased the domestic hot water (DHW) flowrate of combination boilers. The small plate heat exchanger has made a great impact in domestic heating and hot-water. Larger commercial versions use gaskets between the plates, whereas smaller versions tend to be brazed.
It is used in some household stoves [1] and in some industrial process vessels (tanks), such as shell and tube heat exchangers, chemical reactors, and static mixers. Baffles are an integral part of the shell and tube heat exchanger design. A baffle is designed to support tube bundles and direct the flow of fluids for maximum efficiency.
Aluminum is the most prominently used heat sink material because of its lower cost. [46] Copper heat sinks are a necessity when higher levels of thermal conductivity are needed. An alternative to all-copper or all-aluminum heat sinks is the joining of aluminum fins to a copper base. [47] Copper heat sinks are die-cast and bound together in plates.
The purpose of the air preheater is to recover the heat from the boiler flue gas which increases the thermal efficiency of the boiler by reducing the useful heat lost in the flue gas. As a consequence, the flue gases are also conveyed to the flue gas stack (or chimney ) at a lower temperature, allowing simplified design of the conveyance system ...
An internal heat exchanger is simply a heat exchanger that uses the cold gas leaving the evaporator coil to cool the high-pressure liquid that is headed into the beginning of the evaporator coil via an expansion device. The gas is used to chill a chamber that normally has a series of pipes for the liquid running through it.
This is the ratio of the fin heat transfer rate to the heat transfer rate of the fin if the entire fin were at the base temperature, = ˙. in this equation is equal to the surface area of the fin. The fin efficiency will always be less than one, as assuming the temperature throughout the fin is at the base temperature would increase the heat ...