Search results
Results from the WOW.Com Content Network
It is composed of a mixture of formaldehyde and concentrated sulfuric acid, which is dripped onto the substance being tested. The United States Department of Justice method for producing the reagent is the addition of 100 mL of concentrated (95–98%) sulfuric acid to 5 mL of 40% formaldehyde.
If boric acid (or some other weak acid) was used, direct acid–base titration is done with a strong acid of known concentration. HCl or H 2 SO 4 can be used. Indirect back titration is used instead if strong acids were used to make the standard acid solution: strong base of known concentration (like NaOH) is used to neutralize the solution.
The Liebermann reagent named after Hungarian chemist Leo Liebermann (1852-1926) is used as a simple spot-test to presumptively identify alkaloids as well as other compounds. It is composed of a mixture of potassium nitrite and concentrated sulfuric acid. [1] [2] 1 g of potassium nitrite is used for every 10 mL of sulfuric acid. [3]
If dilute acid is not used, the early precipitation of 4th group cations (if present in solution) may occur, thus leading to misleading results. Acids beside HCl are rarely used. Sulfuric acid may lead to the precipitation of the 5th group cations, whereas nitric acid oxidises the sulfide ion in the reagent, forming colloidal sulfur.
For Salkowski test's procedure one needs a sample, that is to be tested for sterols, as well as chloroform and concentrated sulfuric acid that represent Salkowski's reagent. Usually the solution of chloroform and the sample is prepared first and later treated with concentrated sulfuric (VI) acid. After that the whole solution needs to be shaken ...
The test is based on the observation that a suitable amount of sulfuric acid added to the milk will dissolve proteins and other components, except the fat. Heating and centrifuging cause the fat to separate and float to the top, in a layer free of bubbles. The amount of fat in the milk can then be estimated from the volume of that layer.
Green death is a solution used to test the resistance of metals and alloys to corrosion. It consists of a mixture of sulfuric acid, hydrochloric acid, iron(III) chloride and copper(II) chloride and its boiling point is at approximately 103 °C. Its typical chemical composition is given in the table hereafter: [1] [2] [3] [4]
A 0.5 McFarland standard is prepared by mixing 0.05 mL of 1.175% barium chloride dihydrate (BaCl 2 •2H 2 O), with 9.95 mL of 1% sulfuric acid (H 2 SO 4). [ 1 ] Now there are McFarland standards prepared from suspensions of latex particles, which lengthens the shelf life and stability of the suspensions.