enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Gear inches - Wikipedia

    en.wikipedia.org/wiki/Gear_inches

    Simplified diagram of gear inches: As the rear sprocket is halfed in size, the distance traveled by the rear wheel doubles, at half the torque. Gear inches is an imperial measure corresponding to the diameter in inches of the drive wheel of a penny-farthing bicycle with equivalent ( direct-drive ) gearing.

  3. Roller chain - Wikipedia

    en.wikipedia.org/wiki/Roller_chain

    Roller chain and sprocket The sketch of roller chain, Leonardo da Vinci, Codex Atlanticus. Roller chain or bush roller chain is the type of chain drive most commonly used for transmission of mechanical power on many kinds of domestic, industrial and agricultural machinery, including conveyors, wire- and tube-drawing machines, printing presses, cars, motorcycles, and bicycles.

  4. Sprocket - Wikipedia

    en.wikipedia.org/wiki/Sprocket

    16 tooth sprocket. Do = Sprocket diameter. Dp = Pitch diameter A sprocket and roller chain. A sprocket, [1] sprocket-wheel [2] or chainwheel is a profiled wheel with teeth that mesh with a chain, rack or other perforated or indented material. [3] [4] The name 'sprocket' applies generally to any wheel upon which radial projections engage a chain ...

  5. List of gear nomenclature - Wikipedia

    en.wikipedia.org/wiki/List_of_gear_nomenclature

    This page lists the standard US nomenclature used in the description of mechanical gear construction and function, together with definitions of the terms. The terminology was established by the American Gear Manufacturers Association (AGMA), under accreditation from the American National Standards Institute (ANSI).

  6. Belt (mechanical) - Wikipedia

    en.wikipedia.org/wiki/Belt_(mechanical)

    In large speed ratios or small central distances, the angle of contact between the belt and pulley may be less than 180°. If this is the case, the drive power must be further increased, according to manufacturer's tables, and the selection process repeated. This is because power capacities are based on the standard of a 180° contact angle.

  7. Gear - Wikipedia

    en.wikipedia.org/wiki/Gear

    The contact ratio in a transverse plane. It is the ratio of the angle of action to the angular pitch. For involute gears it is most directly obtained as the ratio of the length of action to the base pitch. Face contact ratio, m F or ε β The contact ratio in an axial plane, or the ratio of the face width to the axial pitch.

  8. Spur gear - Wikipedia

    en.wikipedia.org/wiki/Spur_gear

    Spur gear. Spur gears or straight-cut gears are the simplest type of gear.They consist of a cylinder or disk with teeth projecting radially. Viewing the gear at 90 degrees from the shaft length (side on) the tooth faces are straight and aligned parallel to the axis of rotation.

  9. Chain drive - Wikipedia

    en.wikipedia.org/wiki/Chain_drive

    One problem with roller chains is the variation in speed, or surging, caused by the acceleration and deceleration of the chain as it goes around the sprocket link by link. It starts as soon as the pitch line of the chain contacts the first tooth of the sprocket. This contact occurs at a point below the pitch circle of the sprocket.