Search results
Results from the WOW.Com Content Network
A thyristor (/ θ aɪ ˈ r ɪ s t ər /, from a combination of Greek language θύρα, meaning "door" or "valve", and transistor [1]) is a solid-state semiconductor device which can be thought of as being a highly robust and switchable diode, allowing the passage of current in one direction but not the other, often under control of a gate electrode, that is used in high power applications ...
The current in the TCR is varied from maximum (determined by the connection voltage and the inductance of the reactor) to almost zero by varying the "Firing Delay Angle", α. α is defined as the delay angle from the point at which the voltage becomes positive to the point at which the thyristor valve is turned on and current starts to flow.
The principle of four-layer p–n–p–n switching was developed by Moll, Tanenbaum, Goldey, and Holonyak of Bell Laboratories in 1956. [1] The practical demonstration of silicon controlled switching and detailed theoretical behavior of a device in agreement with the experimental results was presented by Dr Ian M. Mackintosh of Bell ...
An IGCT is a special type of thyristor. It is made of the integration of the gate unit with the Gate Commutated Thyristor (GCT) wafer device. The close integration of the gate unit with the wafer device ensures fast commutation of the conduction current from the cathode to the gate. The wafer device is similar to a gate turn-off thyristor (GTO).
A gate turn-off thyristor (GTO) is a special type of thyristor, which is a high-power (e.g. 1200 V AC) semiconductor device. It was invented by General Electric . [ 1 ] GTOs, as opposed to normal thyristors, are fully controllable switches which can be turned on and off by their gate lead.
The thyristor power controller switches 60% of the solid waves to the load while blocking 40%. The operating mode is to be regarded as unproblematic. Only in the case of a too weakly designed network, it is possible for illuminating installations which are connected to the same network to have undesired luminance fluctuations (flicker effect).
A Voltage controller thyristor based dimmer rack An electrical schematic for a typical SCR-based light dimmer. A voltage controller, also called an AC voltage controller or AC regulator is an electronic module based on either thyristors, triodes for alternating current, silicon-controlled rectifiers or insulated-gate bipolar transistors, which converts a fixed voltage, fixed frequency ...
The drawback of connecting a MOSFET in series is that it has to carry the main thyristor current, and it also increases the total voltage drop by about 0.3 to 0.5V and its corresponding losses. Similar to a GTO , the ETO has a long turn-off tail of current at the end of the turn-off and the next turn-on must wait until the residual charge on ...