Search results
Results from the WOW.Com Content Network
When cascading flip-flops which share the same clock (as in a shift register), it is important to ensure that the t CO of a preceding flip-flop is longer than the hold time (t h) of the following flip-flop, so data present at the input of the succeeding flip-flop is properly "shifted in" following the active edge of the clock.
In digital electronics, a synchronous circuit is a digital circuit in which the changes in the state of memory elements are synchronized by a clock signal. In a sequential digital logic circuit, data is stored in memory devices called flip-flops or latches. The output of a flip-flop is constant until a pulse is applied to its "clock" input ...
D : Q; where Dff is the D-input of a D-type flip-flop, D is the module information input (without CE input), and Q is the D-type flip-flop output. This type of clock gating is race-condition-free and is preferred for FPGA designs. For FPGAs, every D-type flip-flop has an additional CE input signal.
Digital phase detectors can also be based on a sample and hold circuit, a charge pump, or a logic circuit consisting of flip-flops. When a phase detector based on logic gates is used in a PLL, it can quickly force the VCO to synchronize with an input signal, even when the frequency of the input signal differs substantially from the initial ...
In digital electronics, especially computing, hardware registers are circuits typically composed of flip-flops, often with many characteristics similar to memory, such as: [citation needed] The ability to read or write multiple bits at a time, and; Using an address to select a particular register in a manner similar to a memory address.
Asynchronous circuits and theory surrounding is a part of several steps in integrated circuit design, a field of digital electronics engineering. Asynchronous circuits are contrasted with synchronous circuits, in which changes to the signal values in the circuit are triggered by repetitive pulses called a clock signal. Most digital devices ...
When the input is below a different (lower) chosen threshold the output is low, and when the input is between the two levels the output retains its value. This dual threshold action is called hysteresis and implies that the Schmitt trigger possesses memory and can act as a bistable multivibrator (latch or flip-flop). There is a close relation ...
In digital computing, the Muller C-element (C-gate, hysteresis flip-flop, coincident flip-flop, or two-hand safety circuit) is a small binary logic circuit widely used in design of asynchronous circuits and systems. It outputs 0 when all inputs are 0, it outputs 1 when all inputs are 1, and it retains its output state otherwise.