Search results
Results from the WOW.Com Content Network
The goal of EGR is thus to reduce NO x production by reducing the combustion temperatures. In modern diesel engines, the EGR gas is usually cooled with a heat exchanger to allow the introduction of a greater mass of recirculated gas. However, uncooled EGR designs do exist; these are often referred to as hot-gas recirculation (HGR).
Therefore, the low speed of the training phase is a limitation of SVMs when it comes to its usage in fault detection and diagnosis cases. [20] Time domain waveform (top) and CWTS (bottom) of a normal signal. Artificial Neural Networks (ANNs) are among the most mature and widely used mathematical classification algorithms in fault detection and ...
The 6.4 L also has a DPF and dual EGR coolers which are capable of reducing exhaust gas temps by up to 1,000 degrees before they reach the EGR valve and mix with the intake charge. The DPF traps soot and particulates from the exhaust and virtually eliminates the black smoke that most diesel engines expel upon acceleration. The engine computer ...
Cordierite Diesel Particulate Filter on GM 7.8 Isuzu. Unlike a catalytic converter which is a flow-through device, a DPF retains bigger exhaust gas particles by forcing the gas to flow through the filter material before exiting; [2] [29] however, the DPF does not retain small particles.
A cold start is an attempt to start a vehicle's engine when ambient temperatures are much lower than its normal operating temperature. [1] A cold start can be difficult for an engine due to higher viscosity of oil and fuel in cold temperatures.
E815 Other motor vehicle traffic accident involving collision on the highway; E816 Motor vehicle traffic accident due to loss of control without collision on the highway; E817 Noncollision motor vehicle traffic accident while boarding or alighting; E818 Other noncollision motor vehicle traffic accident; E819 Motor vehicle traffic accident of ...
Every time an electrical power device (for example: heaters, lamps, motors, transformers or similar power loads) turns on or off, its switch, relay or contactor transitions either from a CLOSED to an OPEN state ("BREAK") or from an OPEN to a CLOSED state ("MAKE"), under load, an electrical arc occurs between the two contact points (electrodes) of the switch.
Vehicle emissions control is the study of reducing the emissions produced by motor vehicles, especially internal combustion engines.The primary emissions studied include hydrocarbons, volatile organic compounds, carbon monoxide, carbon dioxide, nitrogen oxides, particulate matter, and sulfur oxides.