Search results
Results from the WOW.Com Content Network
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
The most common types of indoor antennas are the dipole [2] ("rabbit ears"), which work best for VHF channels, and loop antennas, which work best for UHF. [3] Outdoor antennas on the other hand are designed to be mounted on a mast on top of the owner's house, [4] or in a loft or attic where the dry conditions and increased elevation are ...
8-Port TV Distribution Amplifier. For households with multiple TVs, the Antennas Direct 8-Port TV Distribution Amplifier can split a signal with no noticeable impact on signal quality.
A cellular repeater (also known as cell phone signal booster or cell phone signal amplifier) is a type of bi-directional amplifier used to improve cell phone reception. [citation needed] A cellular repeater system commonly consists of a donor antenna that receives and transmits signal from nearby cell towers, coaxial cables, a signal amplifier, and an indoor rebroadcast antenna.
The first full scale beam waveguide antenna was the 64 meter antenna at the Usuda Deep Space Center, Japan, built in 1984 by the Japan Aerospace Exploration Agency. [6] After the Jet Propulsion Lab (JPL) tested this antenna and found it better than their conventional 64-meter antennas, [ 7 ] they too switched to this method of construction for ...
A beam waveguide antenna is a type of complicated Cassegrain antenna with a long radio wave path to allow the feed electronics to be located at ground level. It is used in very large steerable radio telescopes and satellite ground antennas, where the feed electronics are too complicated and bulky, or requires too much maintenance and alterations, to locate on the dish; for example those using ...
A Pringles cantenna for Wi-Fi. The cylinder portion of the can may consist of metal-coated paperboard.. Although some designs are based on a Pringles potato chips can, this tube is too narrow to increase the 2.4 GHz signal by a useful amount, [1] although at 5 GHz it would be about the right size.
An antenna control unit utilizes the resulting difference signal to select the optimum signal strength for the particular step of the search pattern. This system is particularly applicable to extremely high frequency communication channels (86 GHz and above) which are subject to atmospheric distortion and noise .