Search results
Results from the WOW.Com Content Network
IPC is a trade association whose aim is to standardize the assembly and production requirements of electronic equipment and assemblies. IPC is headquartered in Bannockburn, Illinois, United States with additional offices in Washington, D.C. Atlanta, Ga., and Miami, Fla. in the United States, and overseas offices in China, Japan, Thailand, India, Germany, and Belgium.
1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:
The Wiring Harness Manufacturer's Association is a trade group for American manufacturers of wiring harnesses, electronic cable assemblies, and cord sets, along with their suppliers and distributors. [1] It publishes the widely used standard IPC/WHMA-A-620 Acceptability of Electronic Wire Harnesses and Cables jointly with IPC. [2]
A cable laced wiring harness installed in a component of a Tesla coil Harness of car audio cables. A cable harness, also known as a wire harness, wiring harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. [1]
IEC 60055 Paper-insulated metal-sheathed cables for rated voltages up to 18/30 kV (with copper or aluminium conductors and excluding gas-pressure and oil-filled cables) IEC 60059 IEC standard current ratings; IEC 60060 High-voltage test techniques; IEC 60061 Lamp caps and holders together with gauges for the control of interchangeability and safety
Structured cabling design and installation is governed by a set of standards that specify wiring data centers, offices, and apartment buildings for data or voice communications using various kinds of cable, most commonly Category 5e (Cat 5e), Category 6 (Cat 6), and fiber-optic cabling and modular connectors.
The Category 7 cable standard was ratified in 2002, and primarily introduced to support 10 gigabit Ethernet over 100 m of copper cabling. [2] It contains four twisted copper wire pairs, just like the earlier standards, terminated either with GG45 electrical connectors or with TERA connectors rated for transmission frequencies of up to 600 MHz.
Hermes is a machine-to-machine communication standard used in the SMT assembly industry. [1]IPC-HERMES-9852. It is a successor to the SMEMA standard, introducing improvements such as: simpler physical wiring (Ethernet), use of popular data transmission formats (TCP/IP and XML), reduced number of barcode scanners (required only once at the beginning of the line), transmission of board data ...