Search results
Results from the WOW.Com Content Network
The word pulse in the term pulse-code modulation refers to the pulses to be found in the transmission line. This perhaps is a natural consequence of this technique having evolved alongside two analog methods, pulse-width modulation and pulse-position modulation , in which the information to be encoded is represented by discrete signal pulses of ...
It uses three output levels: + (positive pulse), 0 (no pulse), and; − (negative pulse). This means we have 2 4 = 16 input combinations to represent, using 3 3 = 27 output combinations. 000 is not used to avoid long periods without a transition. 4B3T uses a paired disparity code to achieve an overall zero DC bias: six triplets are used which have no DC component (0+−, 0−+, +0−, −0 ...
Differential pulse-code modulation (DPCM) is a signal encoder that uses the baseline of pulse-code modulation (PCM) but adds some functionalities based on the prediction of the samples of the signal. The input can be an analog signal or a digital signal .
The binary signal is encoded using rectangular pulse-amplitude modulation with polar NRZ(L), or polar non-return-to-zero-level code. In telecommunications, a non-return-to-zero (NRZ) line code is a binary code in which ones are represented by one significant condition, usually a positive voltage, while zeros are represented by some other significant condition, usually a negative voltage, with ...
DM is the simplest form of differential pulse-code modulation (DPCM) where the difference between successive samples is encoded into n-bit data streams. In delta modulation, the transmitted data are reduced to a 1-bit data stream representing either up (↗) or down (↘). Its main features are:
Sub-band coding is used in the G.722 codec which uses sub-band adaptive differential pulse code modulation (SB-ADPCM) within a bit rate of 64 kbit/s. In the SB-ADPCM technique, the frequency band is split into two sub-bands (higher and lower) and the signals in each sub-band are encoded using ADPCM.
Pulse compression is a signal processing technique commonly used by radar, sonar and echography to either increase the range resolution when pulse length is constrained or increase the signal to noise ratio when the peak power and the bandwidth (or equivalently range resolution) of the transmitted signal are constrained.
Trellis-coded pulse-amplitude modulation (TC-PAM) is the modulation format that is used in HDSL2 and G.SHDSL.It is a variant of trellis coded modulation (TCM) which uses a one-dimensional pulse-amplitude modulation (PAM) symbol space, as opposed to a two-dimensional quadrature amplitude modulation (QAM) symbol space. [1]