enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. 7mm Shooting Times Westerner - Wikipedia

    en.wikipedia.org/wiki/7mm_Shooting_Times_Westerner

    The 7mm Shooting Times Westerner, sometimes referred to as the 7mm STW, began as a wildcat rifle cartridge developed by Layne Simpson, Field Editor of Shooting Times, in 1979. [3] It is an 8mm Remington Magnum case that has been "necked down" (narrowing the case opening) by 1 mm to accept 7 mm (.284 in) bullets.

  3. Chamber pressure - Wikipedia

    en.wikipedia.org/wiki/Chamber_pressure

    Within firearms, chamber pressure is the pressure exerted by a cartridge case's outside walls on the inside of a firearm's chamber when the cartridge is fired. The SI unit for chamber pressure is the megapascal (MPa), while the American SAAMI uses the pound per square inch (psi, symbol lbf/in 2) and the European CIP uses bar (1 bar is equal to 0.1 MPa).

  4. Caliber conversion device - Wikipedia

    en.wikipedia.org/wiki/Caliber_conversion_device

    Cartridge adapters have also been made to use .38 caliber handgun cartridges with bullet diameters of approximately .357-inch (9.1 mm) in .35 caliber rifles designed for bullets of .358-inch (9.1 mm) diameter. [3] Supplemental chambers in .22 caliber, and potentially .17 caliber as well, pose a special problem not shared by larger calibers.

  5. Gauge (firearms) - Wikipedia

    en.wikipedia.org/wiki/Gauge_(firearms)

    The move to s [1] teel shot reduced the use of 16 and 20 gauges for waterfowl hunting, and the shorter, 2 + 3 ⁄ 4-inch (70 mm), 12-gauge shells as well. However, the 3 + 1 ⁄ 2-inch (89 mm) 12-gauge shell, with its higher SAAMI pressure rating of 14,000 psi (97 MPa) compared to standard 2 + 3 ⁄ 4-inch (70 mm) and 3-inch (76 mm) 12-gauge ...

  6. Chamber (firearms) - Wikipedia

    en.wikipedia.org/wiki/Chamber_(firearms)

    A barrel chamber with pressure relief ports that allows gas to leak around the cartridge during extraction. Basically, the opposite of a fluted chamber, as it is intended for the cartridge to stick to the chamber wall making a slight delay of extraction. This requires a welded-on sleeve with an annular groove to contain the pressure. [8]

  7. Small arms ammunition pressure testing - Wikipedia

    en.wikipedia.org/wiki/Small_arms_ammunition...

    Other benefits of the SAAMI conformal transducer are: very adaptive to the high volume quality control testing demands of commercial and law enforcement ammunition production; protection of the transducer from direct exposure to the high temperature combustion gases and hence a comparatively long service life; 80,000 psi (551.6 MPa) maximum ...

  8. 7mm-08 Remington - Wikipedia

    en.wikipedia.org/wiki/7mm-08_Remington

    The 7mm-08 Remington is a rifle cartridge that is almost a direct copy of a wildcat cartridge developed around 1958 known as the 7mm/308. As these names would suggest, it is the .308 Winchester case necked down to accept 7 mm (.284) bullets with a small increase in case length.

  9. NATO EPVAT testing - Wikipedia

    en.wikipedia.org/wiki/NATO_EPVAT_testing

    Pressure recorded in NATO design EPVAT Barrel with Kistler 6215 Transducer, HPI GP6 Transducer or by equipment to C.I.P. requirements 9 mm (9×19mm NATO) Designed to chamber NATO ammunition: 252.0 / (36,550) 315.0 / (45,687) Pressure recorded in C.I.P. design barrel at mid-case position 12.7 mm (12.7×99mm NATO) Designed to chamber NATO ammunition